How Does One Remove These Sun Visor Warning Stickers?

[AMCfoxbody]

I hated them

Look how nice and clean this looks

What was your process?

Sponsored

 

[Fast]

Forget about it for a little while. Make sure it's a really hot day. Then attempt.

 

[Montana]

I hated them

Look how nice and clean this looks

Did you just buy new ones that don't have the sticker?

 

[Hillbilly]

Did you just buy new ones that don't have the sticker?

Goo Gone, fingernails, and patience. I'm really glad I did it. Those warning labels were hideous.

 

[Montana]

Goo Gone, fingernails, and patience. I'm really glad I did it. Those warning labels were hideous.

Color me inspired. Never really cared before, but these ones have labels everywhere!

Anyone try heat? I have a heat gun so I may try that first, but gotta be very careful.

 

[jb_cb900]

Thanks for the tips. Removed the visors and used a hair dryer to heat up stickers. Stickers are a plastic film and comes off in one piece. Hest and peel, repeat. Peel off slowly at a sharp angle. I used isopropyl alcohol for adhesive removal. Lay a soak paper towel on the adhesive for a few minute and it ruds off pretty easily.

 

[clavicus]

Thanks for the tips. Removed the visors and used a hair dryer to heat up stickers. Stickers are a plastic film and comes off in one piece. Hest and peel, repeat. Peel off slowly at a sharp angle. I used isopropyl alcohol for adhesive removal. Lay a soak paper towel on the adhesive for a few minute and it ruds off pretty easily.

Looks clean!

 

[Glen Baker LLC]

Thanks for the tips. Removed the visors and used a hair dryer to heat up stickers. Stickers are a plastic film and comes off in one piece. Hest and peel, repeat. Peel off slowly at a sharp angle. I used isopropyl alcohol for adhesive removal. Lay a soak paper towel on the adhesive for a few minute and it ruds off pretty easily.

Looks great

 

[jb_cb900]

Thanks. It takes 3-4 minutes to get each sticker off and about the same to remove the adhesive. Highly recommend removing visor the from vehicle. Pop off dress cap and remove one Torx bolt (20#). Swing the assembly towards you and it will come out with a little wiggling. Disconnect the power wire and take inside where its comfortable.

 

[Glen Baker LLC]

Thanks. It takes 3-4 minutes to get each sticker off and about the same to remove the adhesive. Highly recommend removing visor the from vehicle. Pop off dress cap and remove one Torx bolt (20#). Swing the assembly towards you and it will come out with a little wiggling. Disconnect the power wire and take inside where its comfortable.

Boy can I have fun with my interpretation. Hmmm 🫣


In all seriousness thank you very much for your time and explanation.
Sincerely,
GB
Because I have a XLT. There is no light in the vanity in mirrors. I don't think I'll have to unplug anything.

 

[jb_cb900]

I have an XLT, also, with no lights in the vanity. I was surprised to see the wires. Guess its easier to install the desire mirror assembly as opposed to stocking 2 different visors. The connector is covered but look closely and you will see the release tab. It pulls apart very easily.

 

[Glen Baker LLC]

I have an XLT, also, with no lights in the vanity. I was surprised to see the wires. Guess its easier to install the desire mirror assembly as opposed to stocking 2 different visors. The connector is covered but look closely and you will see the release tab. It pulls apart very easily.

Thank you for the insight.

 

[Tom 71 Maverick 24]

You can't, it voids the warranty like a mattress tag if you do -)

When I was younger, a LOT younger, my older brother would torment me, actually singing a song - "Do NOT remove this tag under penalty of law".

I was a bit afraid to ever remove a mattress tag for several years after that.

 

[Nw_adventure]

When I was younger, a LOT younger, my older brother would torment me, actually singing a song - "Do NOT remove this tag under penalty of law".

I was a bit afraid to ever remove a mattress tag for several years after that.

What a dick - lol

 

[JPinPA]

Thanks for the tips. Removed the visors and used a hair dryer to heat up stickers. Stickers are a plastic film and comes off in one piece. Hest and peel, repeat. Peel off slowly at a sharp angle. I used isopropyl alcohol for adhesive removal. Lay a soak paper towel on the adhesive for a few minute and it ruds off pretty easily.

Gonna add this onto the to-do list. Thanks!

Sponsored