I was order#1984766, probably just a couple switches behind you lolMine just shipped!
knew I should have ordered it last month
Sponsored
I was order#1984766, probably just a couple switches behind you lolMine just shipped!
Damn that sucks.I was order#1984766, probably just a couple switches behind you lol
knew I should have ordered it last month
Don't feel too bad, mine isn't even here yet and I've got several parts already and a few still in the post.And here I was thinking that I was done modifying my Mav. *sigh*
My exact thoughts on the switch wire to the BCM.Ok i got my set of fog lights from Diode Dynamics and got their wire harness with me and wiring diagram. I have been sick for the past 3 days with covid or flu but unable to touch my truck or think straight stucked on bed.
Heres a picture of the option if you want to use their harness and my bcm terminals to fog lights kit. If you prefer their harness then what i would do its wire up everything like they say. With the power with fuse and relay and ground to battery what ever. But the difference its where it says Switch Input install just 1 pin from the bcm to there and you should be able to use the f150 fog light switch.
Or wait for me to get better health wise and post a how to when i get a chance this week.
Anyone know how to remove the the light switch for replacement?
Cool thanks, I thought id have to take apart that whole bottom dash section to get behind it.Plastic panel removal tool pry it gentel
But heres the oem instructions. I didn't do it this way but this way its better way to do it.Cool thanks, I thought id have to take apart that whole bottom dash section to get behind it.
Thanks Tony
Nope. It pops right out. Look at your new switch to see where all of the tabs are to figure out the pry points.Cool thanks, I thought id have to take apart that whole bottom dash section to get behind it.
Thanks Tony
No, because you shouldn't do anything with the wiring at the switch itself. The only four wires there are: Ground, Power, Cargo (Gr/Vt), and LIN [Local Interconnect Network] (Blu/Gy) with the lattermost the digital communication line to the BCM that actual changes in the lighting are transmitted over.Perfect, got it. Should I have more wires on this harness for the foglight conversion. Seems there’s only 4.