I was under the impression there is a 2 hour wait for the 12v to settle in the 8 hour window. Most likely the BMS will check the voltage periodically and run the procedure when the voltage settles. In say one or two ten minutes periods.To be clear.
If you replace your battery with a battery from Costco or Sam's and that battery goes bad. Ford is under no obligation to replace it even if your truck is still under full bumper to bumper warranty. Replacing with such does not negate your full vehicle warranty.
Give me a moment please..... this is going to be a long and involved post
Removing the battery clamp nut isn't the problem, but reinstalling it is.![]()
![]()
I don't know if I will remove the plastic surround or order a 10 mm magnetic socket. I would think it's harder to get the battery hold down clamp in the proper position with the plastic surround on.
![]()
Then there is the process of making sure the new battery is charged 100% before doing the BMS relearn. This is something most places that install your battery probably will not do.
From the manual.
![]()
This is about as comprehensive a post as I can help you out with.
Good Luck.
Sponsored