Strut tower brace Steeda

[little kenny]

has anyone bought one from sheeda for your maverick and is each end sppose to be the same angle ?? mine dosnt seem to be the same on each end

Sponsored

 

[Tom 71 Maverick 24]

Do you mean Steeda? I don't have one, but just wanting to clarify.

 

[Fcnrwy]

Well does your Steeda, it look like this...

Passenger-Side

Drivers-Side

Jerry

 

[little kenny]

Do you mean Steeda? I don't have one, but just wanting to clarify.

yes i meam steeda

 

[little kenny]

Well does your Steeda, it look like this...

Passenger-Side

Drivers-Side

Jerry

yes mine look like that i just didnt installed cus each in is at different angles not sure if it sppose to be like that or not will check angle after work got an angle finder at work

 

[Fcnrwy]

The angle is determined by the original bolt location (angle).
You are replacing one of the front strut bolts with a (supplied longer one)..

Jerry

 

[Back2Trucking]

yes i meam steeda

Ha! The original post made me wonder, because “sheeda” (or shida) is a Swahili word for trouble or problem. Which might be appropriate in this case.

 

[little kenny]

Yes I have the bolt that come with it just wanted to know if mine was defective or improperly manufactured before I install. The angle on the end steel different. I’m smart enough to know I don’t know enough and should ask question. Sorry about the e bad spelling for steeda

 

[agmonaco]

What is its purpose? Why would you need this?

 

[MAGPLM]

Have it on both of my vehicles. Works fine, and looks like that.

 

[Fcnrwy]

What is its purpose? Why would you need this?

It is NOT a mandatory thing. It is simply a Strut (support) that connects the two Front Suspension towers and helps keeping the body "stiff".
Which means, Less body flexing that occurs overtime.
It was a common thing to add to early Mustangs.. My Brother had a few...
Installing one doesn't hurt...

Jerry

 

[Skulls Road]

What is its purpose? Why would you need this?

It's just for looks.

 

[Glen Baker LLC]

yes mine look like that i just didnt installed cus each in is at different angles not sure if it sppose to be like that or not will check angle after work got an angle finder at work

You could always order another one.
Compare the two side by side.
If they are identical. Then keep one and send one back.
The probability that you would be sent 2 defective braces, would be highly unlikely.
Unless you already know the proper angle.
What will using a angle finder due?
Good luck.
GB

 

[agmonaco]

It is NOT a mandatory thing. It is simply a Strut (support) that connects the two Front Suspension towers and helps keeping the body "stiff".
Which means, Less body flexing that occurs overtime.
It was a common thing to add to early Mustangs.. My Brother had a few...
Installing one doesn't hurt...

Jerry

Thx

 

[Blue_Max]

What is its purpose? Why would you need this?

It reduces body flex, which tightens up handling. Reduced flex also helps keep things from working their way loose due to the constant flexing.

Sponsored