- Thread starter
- #1
Just curious what all of you use to clean the rough finish on the dash and door panels. In the past I used Armor All but I’m not sure if this would damage the Mavericks rough finish. Ideas please?
Sponsored
Swiffer duster. If there's dirt I use an antibacterial wipe.Just curious what all of you use to clean the rough finish on the dash and door panels. In the past I used Armor All but I’m not sure if this would damage the Mavericks rough finish. Ideas please?
This right here. Make sure it's a quality microfiber, like 3M, not a Dollar General cheapie. I like a weak solution of Simple Green as a topical cleaner. Buy it in concentrate, and custom mix your own, pending your task.Microfiber will get down into the texture. I just use a damp (water) microfiber cloth most of the time. If I need more than that, I just use a mild soap. Armor All isn't a cleaner, (unless you're talking about a cleaner product that they make) and it doesn't protect all that well either, compared to more modern protectants.
This is what I do.Microfiber will get down into the texture. I just use a damp (water) microfiber cloth most of the time. If I need more than that, I just use a mild soap. Armor All isn't a cleaner, (unless you're talking about a cleaner product that they make) and it doesn't protect all that well either, compared to more modern protectants.
My go to is to use Optimum No Rinse mixed with water at a dilation of 1:128. With how little takes to even make a bottle of 16oz of cleaner it is super cheap. to clean with it I normally have two microfibers and I spray the product onto one of them wipe down with that and then dry with the other one if needed. If I need a bit of extra cleaning power I will use a scrub ninja pad. Personally I haven't ran into anything that needs anything past that but I do clean my truck about once a week With onr I haven't ever noticed anything left over and it a rather gentle cleaner so should be all good. You can do a test spot to double check though .Just curious what all of you use to clean the rough finish on the dash and door panels. In the past I used Armor All but I’m not sure if this would damage the Mavericks rough finish. Ideas please?