Loose splash shield flapping and dragging after oil change.

[svtmrc]

2022 Maverick EcoBoost Non-AWD
82k miles

I had an oil change done recently, and about 500 miles later the underbody splash shield came loose. It started flapping in the wind at highway speeds and dragging at lower speeds.

I took it back to the oil change shop, and they secured it with a few zip ties. It's holding for now, but I'd really like to put it back the way it was from the factory rather than relying on zip ties.

Can anyone help me identify which OEM screws, clips, retainers, or fasteners are supposed to be holding it in place? I'd like to replace any missing hardware and restore it to like-new condition.

Any part numbers, diagrams, or advice would be greatly appreciated.

Sponsored

 

[DrNoobNStein]

If you could post pictures of your splash shield. Not sure what the extent of damage or ziptiery is being utilized to secure it. If nobody has any pics handy I’ll grab some for you. I honestly wanted to check on my new CV axles that were just replaced (warranty wobble).

 

[Glen Baker LLC]

Google it

 

[HeyBales]

And when you reinstall - they probably failed to tuck it above the front edge of bumper - so it was easier to catch the wind.

And probably every change has over-tightened and striped the wimpy holders.

ETA:
Glenn - I think that other variety pack you had was better.
Maybe not OEM, but better.

 

[Glen Baker LLC]

And when you reinstall - they probably failed to tuck it above the front edge of bumper - so it was easier to catch the wind.

And probably every change has over-tightened and striped the wimpy holders.

ETA:
Glenn - I think that other variety pack you had was better.
Maybe not OEM, but better.

Better might be questionable.
The OP requested OEM.
So I googled and posted OEM.

 

[svtmrc]

@Glen Baker LLC - Of course I've googled it. I'm a bit unsure exactly what I need which is why I'm here asking for advice.

@DrNoobNStein & all - Please see my photos below as requested.

There are 3 position points fastened with zip ties. The rear of the pictures is what was loose and dragging. The front towards the front bumper did not/has not yet become loose.

 

[DrNoobNStein]

I totally misread your post. Yeah those splash shields are a pain. I partially tore the passenger side and to make the repair it has a few different bolt and fasteners. Hold on

 

[DrNoobNStein]

MTC driver side splash shield


it was taking forever to upload so I posted to YouTube. Hope this helps

 

[Johnkn]

The only thing more stupid than the oil change guy not properly securing the shield initially is when he then zip-tied it and cut the tag ends of the ties at 1" and a nice 30* angle to cut the next person's hands who fixes the issue..


.

 

[BK007]

 

[notfast]

@Glen Baker LLC - Of course I've googled it. I'm a bit unsure exactly what I need which is why I'm here asking for advice.

Looks like you need HN3 and HS1, but someone more knowledgeable could verify.

Actual part numbers for HN3 and HS1 can be found here:
https://www.ford.com/product/parts?...=446281003&make=Ford&model=Maverick&year=2022

 

[svtmrc]

Thank you all very much.

Sponsored