3D Printed Bin for the Bed Cubby

[Dad]

Makes it so much easier to get to small items. Great mod!

Sponsored

 

[johnny99]

To make the bed storage cubby easier to use I drew up and printed a bin that attaches to the lid.

Here is the file if anyone else wants print one.
https://www.printables.com/model/1529076-ford-maverick-flexbed-cubby-bin

Very nice! Will fire up the P1S and melt some PETG.

You're sharing knowing that it's gonna be for sale in multiple places, probably already. I respect that, a lot. Thanks.

Fusion 360?

 

[RodLS]

Very nice! Will fire up the P1S and melt some PETG.

You're sharing knowing that it's gonna be for sale in multiple places, probably already. I respect that, a lot. Thanks.

Fusion 360?

Do you really think there is enough of a market that people would try selling it?

I used Onshape to model it.

 

[johnny99]

Do you really think there is enough of a market that people would try selling it?

I used Onshape to model it.

Yeah I do. Look at some of the accessories for sale here. I'm aware of at least one member sharing a tailgate vent cover that was summarily copied and sold with no compensation or attribution. IP theft is rampant.

 

[Ray_B]

I printed and attached the bin with 3m tape. Works seamlessly! Very well done sir!

 

[SilverBullet2.0]

I am not sure if you are referring to the following cubby from us that can extend to the lower side. Attached picture for you reference, thank you.

https://www.amazon.com/dp/B0D3WVY1HT

This is on my list to purchase for the opposite side as it is just blank empty cavity (left rear) due to not having the light or power supply option.

I also have the separate locking cap for the existing storage lid (right rear).

 

[Thex]

I have also printed and attached with 3M. Nice design and alignment markers!

 

[RichardCranium]

Looks great! I was gonna say, better patent that before the design gets stolen and re-sold on this site by a vendor. Might be too late already!

I am sure it has already been stolen by mabett

 

[RichardCranium]

Yeah I do. Look at some of the accessories for sale here. I'm aware of at least one member sharing a tailgate vent cover that was summarily copied and sold with no compensation or attribution. IP theft is rampant.

I agree.
Thank you for sharing.
I too think you could have sold these. If @P99Guy is still around, you may ask him about selling things. You could probably sell a few to the people that don’t have printers and get compensated for the time you put into the design.

 

[johnny99]

I agree.
Thank you for sharing.
I too think you could have sold these. If @P99Guy is still around, you may ask him about selling things. You could probably sell a few to the people that don’t have printers and get compensated for the time you put into the design.

Thanks, but OP was the designer/creator. I have no interest in printing and selling his design to sell to others for profit. I'll print one for myself when it gets a little warmer this week.

 

[SilverBullet2.0]

This is on my list to purchase for the opposite side as it is just blank empty cavity (left rear) due to not having the light or power supply option.

I also have the separate locking cap for the existing storage lid (right rear).

I am not sure if you are referring to the following cubby from us that can extend to the lower side. Attached picture for you reference, thank you.

https://www.amazon.com/dp/B0D3WVY1HT

Got 'em! Thanks for providing the other 2 bolts for the driver side filler panel that uses 4.

Sponsored