Search results

Just wanted to chime in again. Added a dash cam with a 12volt power port. Used this spreadsheet to change the default 75 minute timeout to 10 minutes. Thanks again!

I used the same 1/2 height strut that you did when I installed mine a few years ago. I was glad to see I wasn't the only one that cut it "short" from the front to keep the original tie down. I just posted last week about using the Mabett bed divider, (linked if you are interested.) Even though...

I have also printed and attached with 3M. Nice design and alignment markers!

I was wondering about if this would be the same for other installs besides my UNISTRUT install. Sorry you are having the same issue (however it does make me feel better that I didn't screw something up with my mods :) ) I am trying to find a longer PIN to replace the spring loaded one. A...

I was incorrect in thinking the pin was hollow. it is solid. I was able to adjust it a couple of mm deeper into the T-bracket. However, and this may be my install, the pin does not protrude past the countersink in the T-bracket making it easy to disengage from its position. I can only speak of...

I may take the locking pin out to see what's up :)

I have installed the Bed divider with Unistrut rails. I do NOT recommend this installation with Unistrut as I had to make extreme modifications, and even then, it doesn't slide as smoothly as I bet it does with factory/Mabett rails. If I had to do it over again - I would get the package with...

I have the half height. I didn't order it since the PROMOTION ended before I got their answer. I am bummed about it!

Sweet it will fit! So i went to order the tailgate WITHOUT the rails and the discount code does not work... :(

This is what I have; 1 5/8" x 13/16" (41.3mm x 21mm) (I have the short one in the bottom pic, but included the dimensions of the taller one for those that may use those.)

I am also in this category! @MABETT, Will this work with the unistrut rails?

Seat itself.

The seat back is easier to remove. it has an elastic that is hooked under the seat and then there is a plastic strip that you unfold/unzip. You will have to cut a slit in the fabric for the airbag cable. Unzip the sides of the seat. You still have to deal with the HOG RINGS that is hold the...

The cases are 3" tall. Any thicker and the seat will not latch. If you notice, the black case is lower. The red case cannot go any lower as it is right above the bolt holding in the jack. If I could lower the red case to the same level as the black one, the seat would latch easier.

As stated - "no BO woofer as I have an XL"

24"x12" - 1 1/2" Dia. Spacing varies as I had to work around the mounting holes.

yes it does.

PETG. Both the brackets and the black and purple toolbox :)

I was hoping to find a third party molle panel that was designed to fit behind the back seat. I never found anything so I went the DIY route with 1/2" plywood. I used the existing mounting holes for the BO amp - (that my XL does NOT have :) ) I designed and 3d Printed the brackets for the...