PINPOINT TEST B: THE AC OUTLET LED (LIGHT EMITTING DIODE) INDICATOR IS NEVER ON
Possible Causes
• Fuse(s)
• direct current/alternating current (DC/AC) inverter
• AC Outlet
• Wiring, terminals or connectors
Visual Inspection and Pre-checks
• Verify the BCM Fuse 6 (10A) is OK.
• Verify the BJB fuse 36 (60A) is OK.
• Inspect the AC outlet for damage.
NOTE: The DC/AC inverter will cease AC output if there is a fault on the LEDs in the outlet or if the LED is not detected as present.
Loose harness connector, faulty outlet LED feedback can cause.
Possible Causes
• Fuse(s)
• direct current/alternating current (DC/AC) inverter
• AC Outlet
• Wiring, terminals or connectors
Visual Inspection and Pre-checks
• Verify the BCM Fuse 6 (10A) is OK.
• Verify the BJB fuse 36 (60A) is OK.
• Inspect the AC outlet for damage.
NOTE: The DC/AC inverter will cease AC output if there is a fault on the LEDs in the outlet or if the LED is not detected as present.
Loose harness connector, faulty outlet LED feedback can cause.
Sponsored