Could, but I wouldn't for a jump connection because of length of wire, gauge size and I'd want the positive wire fused close to the jumper post just in case of a short to chassis somehow.
Any of the bolts that go into the frame or body in the engine compartment should work.
There's 3 existing ground bolts near the jump posts.
I didn't go under the jump negative stud as a few people had trouble with it threading back in tight.
I used the horn mount bolt for my charger negative lug.
For synthetic oil made from natural gas using Gas to Liquids (GTL) in US market seems to be
Pennzoil Platinum and Pennzoil Ultra Platinum. Pennzoil is owned by Shell.
https://blog.amsoil.com/is-motor-oil-made-from-natural-gas-better/
Some links about the VSS for up to 2024MY Fords.
Adding Key Fob Remote Start (2022 XL)
"Key Start Vehicles:
1 Start with ignition key OFF, doors unlocked and VSS system DISARMED.
2 Open driver door (remaining open throughout).
3 Place shifter in the PARK position (remaining in PARK).
4 Depress...
Port Arthur MOTIVA, does, probably high demand causes some to be exported.
It used to be a joint venture with Shell Oil, now fully Aramco owned.
https://www.motiva.com/what-we-do/energy-products/base-oils
"site of the largest base oil plant in the Western Hemisphere"
Clue is the pushbutton added to bottom of dash.
https://www.mavericktruckclub.com/forum/threads/free-gps-mystery-modules-courtesy-of-your-so-cal-ford-dealers.29985/
and
https://www.macheforum.com/site/threads/2m-cars-not-necessarily-fords-hackable-via-hidden-karr-alarm.57194/
General info on Ford's 400W Inverters.
A DTC sets in the BCM when the general electrical fault is detected by the direct current/alternating current (DC/AC) inverter.
Possible Causes
• Fuse(s)
• Direct current/alternating current (DC/AC) inverter
• AC Outlet(s)
• Wiring, terminals or...
'23-'24 Maverick
211-05 Steering Wheel and Column Electrical Components Description and Operation
System Diagram - Conventional Ignition Switch
Ignition Switch System
The BCM controls the ignition modes, including OFF, ACC, ON and START.
This allows some systems to be activated without...
414-05 Voltage Converter/Inverter Description and Operation - 2023 - 2024 Maverick
DC/AC INVERTER
The DC/AC inverter converts 12 volts DC to 110 to 230V volts (Depending on market requirement) AC to power AC devices rated 400 watts or less with the vehicle in park, or 300 watts or less with the...
Sounds like the 12V Power Points are operating normally as designed by Ford, just like the HVAC Climate Control. The owner just has to figure out what that is.
Exterior Lighting - System Operation and Component Description
• The BCM load shed strategy is not active (a message is displayed in...
Easy to forget the various equipment I used to work on.
Notes on a Halon dump at our pipeline SCADA computer room during a thunder storm near Houston in 1993.
"Lightning caused the failure of IDNX node 50 at SPLC's facility in Pasadena.
The lightning strike apparently entered through commercial...
The studs at the 12V battery looked very strong to me.
The 200A fuse cable goes to the High Current Junction box near to the jump post.
The middle stud is the 12V connection for the BMS Sensor.
I had a 1/0 lug on the larger spare stud for a 2000W inverter connection before.
My Escape doors are heavier feeling than the Maverick's doors.
The doors at the check arm looked similar.
On Escape doors if Ford doesn't replace the door on CSP 23B56, they install a $8 reinforcement kit that is pop rivets and a small plate.
If it isn't the check arm assembly making the noise, then I'd wonder if a spot weld is failing like on Escape front doors.
Video: '20-'21 Ford Escape Door Check Broken Spot Welds Fix
Front Door Check Arm Assembly:
May be clogged A/C drain. Drain is like a rubber duckbill I think.
https://www.mavericktruckclub.com/forum/threads/water-dripping-into-passenger-and-driver-side-footwell.68264/post-1130211
Possible one of the Evap Emission valves.
Fuel Vapor Vent Valve: https://www.mavericktruckclub.com/forum/threads/cel-after-over-filling-tank-anyone-else.72650/post-1363431
https://www.mavericktruckclub.com/forum/threads/evap-refueling-vent-valve-failing.63696/post-1170818