Had a Yellow Warning Light Come On and Go Off a few times on the way Home from Work Last Night.

[BLUEOVALRACER]

But couldn't make out what it was it was Dark and like I said it came on and went off a few Times. It was above the Tachometer on My 2025 AWD XLT with the 2.0 EB engine.The supplemental owners Guide shows a bunch of Different Warnings but not where they show up on the dash. Any help would be Great,Thanks

Sponsored

 

[ZABSMAV]

But couldn't make out what it was it was Dark and like I said it came on and went off a few Times. It was above the Tachometer on My 2025 AWD XLT with the 2.0 EB engine.The supplemental owners Guide shows a bunch of Different Warnings but not where they show up on the dash. Any help would be Great,Thanks

I would venture that it is your windshield wash fluid level low. Start by topping that off. If it takes about 3/4 of a gallon, I can almost guarantee that was the cause.

 

[Janno]

I’ve had my Mav for only 3 weeks. 2 days ago, I noticed a yellow light on the dash.

A few minutes after starting my drive, the dash said that my collision sensors were obstructed/malfunctioning, likely due to the morning fog/dew. After my first stop (engine off/on again) the light/warning was gone. Wife and I even got a notification on the Ford App telling her the same thing.

It’s prob the washer fluid as stated above, or maybe wipe the sensors clean

 

[Cancunbadlands]

Windshield wash fluid level going low

 

[BLUEOVALRACER]

I’ve had my Mav for only 3 weeks. 2 days ago, I noticed a yellow light on the dash.

A few minutes after starting my drive, the dash said that my collision sensors were obstructed/malfunctioning, likely due to the morning fog/dew. After my first stop (engine off/on again) the light/warning was gone. Wife and I even got a notification on the Ford App telling her the same thing.

It’s prob the washer fluid as stated above, or maybe wipe the sensors clean

I had that come up for My collision sensors when I took My Mom for blood work early on a cold morning.

 

[BLUEOVALRACER]

Thanks guys I'll check the Washer Fluid but when I drove it Sunday morning the light never came on?

 

[Darryl]

Thanks guys I'll check the Washer Fluid but when I drove it Sunday morning the light never came on?

Probably was the collision sensor. That's come on a few times. It seems to be sensitive on the MAVERICK. It's at the top of the windshield. Morning or evening dew seems to be enough to block it enough to make the warning light come on. When the dew evaporates the light goes out

 

[BLUEOVALRACER]

Probably was the collision sensor. That's come on a few times. It seems to be sensitive on the MAVERICK. It's at the top of the windshield. Morning or evening dew seems to be enough to block it enough to make the warning light come on. When the dew evaporates the light goes out

I think that light is Red and in the Center of the instrument panel when it came on before? This light was Yellow and above the tachometer. I did add Washer Fluid like mentioned but it didn't take a 1/2 gallon to fill it. And the Light never came on again when i drove it Sunday and Monday.

 

[HeyBales]

Get your camera ready - turn key to On - get Pic while all the lights are lit!

 

[BLUEOVALRACER]

Get your camera ready - turn key to On - get Pic while all the lights are lit!

I looked when I pushed the start button with it not started and no light lite up in the spot where the Yellow warning light came on?

 

[HeyBales]

I looked when I pushed the start button with it not started and no light lite up in the spot where the Yellow warning light came on?

When you go to On - every set light should go on to prove light works.
So this must be something else.

Or, perhaps there isn't an On mode with push-button start.
Only Acc mode with no brake press, and Start mode with brake press.
Not sure which is used for the light check. But if all the others lit up - you got it.

There's Engineering mode too, which shows all the lights, perhaps more than the set lights.

 

[Mavster Mechanic]

The trucks won't light up anything when you melt a piston.

But thank gawd they let you know when washer fluid is low!

 

[Carlitos_92]

When you go to On - every set light should go on to prove light works.

Does that work on the 2025s since they are a 100% digital display?

If none of the symbols shown in the symbol glossary in the front part of the 2025 manual ring a bell, there might not be much choice other than to see if it ever comes back again.

 

[HeyBales]

Does that work on the 2025s since they are a 100% digital display?

If none of the symbols shown in the symbol glossary in the front part of the 2025 manual ring a bell, there might not be much choice other than to see if it ever comes back again.

Now that would be nice to see a pic in 25MY Engineering mode - what is considered a set light space, for the normal safety lights.
Would probably confirm too what space is for anything extra.

 

[Blue_Max]

The trucks won't light up anything when you melt a piston.

But thank gawd they let you know when washer fluid is low!

Well, you're not going to be worrying about reduced visibility with a melted piston.

Sponsored