It's why all our passenger seats are manual. Makes room for the ejection mechanism.Isn't that standard equipment nowadays ?
Sponsored
It's why all our passenger seats are manual. Makes room for the ejection mechanism.Isn't that standard equipment nowadays ?
Not a hybridWhy is there no fuel door button under it?
The picture shows a light for the bed,so I'm sure that's what it is.Can someone tell me what the switch on the s left does? Can’t find it in the manual.![]()
That turns on the rear facing T-shirt cannons attached to your third brake light that shoots T-shirts to the crowdCan someone tell me what the switch on the s left does? Can’t find it in the manual.![]()
no, that one is cleverly disguised as an incomprehensible slot by the gear selector.I thought it was the passenger ejection seat switch.
That slot holds a buisness card pretty well, but thats about it. Any ideas what it actually is for or why its even there?no, that one is cleverly disguised as an incomprehensible slot by the gear selector.

Remember the RPM buttons only work during daylight hours. Does not work in the dark.The ones on the right + increase your RPM or - decrease your RPM
To hold cards, parking slips, etc. My Kia had the slot, but it was on the dash. I find it useful.That slot holds a buisness card pretty well, but thats about it. Any ideas what it actually is for or why its even there?
Access card for gates etc.That slot holds a buisness card pretty well, but thats about it. Any ideas what it actually is for or why its even there?
Also - I searched for "slot by the gear selector" and found this post before I asked the question in a new post. I'm sure that makes somebodys day. haha![]()

You got your correct answer twice. Now time for the wise**s answers. Jellyfish launcher is good.
System might think there is an issue if it overdraws what is expected and turn it off.on a more serious note, has anyone tied their under-tonneau LED strips to the cargo light circuit so one could technically light up the cargo bed via that button?
im conflicted if i want it tied to that circuit or be independent via the 12v system already provided within the bed itself