Underbody shield fastener part number needed

[jon72vega]

Today I noticed the shield/splash guard under the driver side doors was hanging down.
I found there are at least 2 missing nuts.
Does anyone have a part number or the size of the nut I need?

Shield hanging down.

Loose shield under driver door by jon72vega, on Flickr

Missing fasteners.

Missing nut by jon72vega, on Flickr

Missing nut by jon72vega, on Flickr

This is what the nut looks like.

The nut by jon72vega, on Flickr

Found this diagram, but could not find a part # for the nut.

shield nut by jon72vega, on Flickr

I Google searched for over 30 minutes and came up with nothing.
Any help in figuring out the correct part # would be appreciated.

Sponsored

 

[papak]

Most likely M6x1.0

 

[Gpp]

Take a good nut and bolt assembly out and match it up at a hardware store or auto parts store.Amazon has them also.

 

[fossil]

@jon72vega
Try searching Amazon for
pal nut
speed nut
thread cutting nut

https://www.amazon.com/Piece-Emblem...s&sp_csd=d2lkZ2V0TmFtZT1zcF9hdGZfbmV4dA&psc=1

 

[ksc83]

Where did you find the diagram for the under body shield? I just had a tire retread fly off a truck and I ran it over and the rear drivers side portion ripped off. Now I’m hearing all sorts of noises like something is loose and jiggling around. Going to need to replace that piece now. Just need the part number.

 

[bgn]

Where did you find the diagram for the under body shield? I just had a tire retread fly off a truck and I ran it over and the rear drivers side portion ripped off. Now I’m hearing all sorts of noises like something is loose and jiggling around. Going to need to replace that piece now. Just need the part number.

This might be useful as a starting point:

https://parts.lakelandford.com/a/Fo...loor-Under-cover--splash-shields/MM22592.html

I'd suggest double checking with the parts diagram available at your local parts counter. The one above seems to be from the service manual and I don't think they have part numbers.

 

[jon72vega]

An update on getting more fasteners.
I purchased these on Amazon. Body Flanged Hex Nut
Had to drill out the hole to 11/64", (I expected I would have to enlarge the hole to make the fasteners work) and Bob's your uncle.

Retainer nut for splash shield by jon72vega, on Flickr

Retainer nut for splash shield by jon72vega, on Flickr

 

[patriotsfan9]

My truck came with 1 missing. I found the part number and verified it fits.

Screw And Spring Washer Part Number: W702413S450B

It was $11.70 for a 4 pack on Ford Parts

 

[starznbutrflyz]

I need the part number for the passenger side cover. I’ve tried looking everywhere and can’t find it or the correct term for it to search by.

 

[BlueSpec1]

I need the part number for the passenger side cover. I’ve tried looking everywhere and can’t find it or the correct term for it to search by.

Felt Splash Shields?
Pillars. Rocker & floor. Under cover & splash shields.
https://parts.lakelandford.com/a/Fo...loor-Under-cover--splash-shields/MM22592.html

 

[The Daley Show]

FYI... Couple of the part numbers above were not for the nut....

Here is what I found... After a lot of looking haha

https://www.eastgatefordpartscanada...21-ford-fender-liner-retainer-nut-w709729s442

 

[The Daley Show]

Again, realizing this is an old post but in case someone else has the same problem...

I found a part number at Eastgate as posted above ... Which looked like the nut we were all looking for.

But, no diameter listed so hard to know for sure...

Searched that part on Amazon and ended up here (https://www.amazon.ca/gp/aw/d/B0H1DGTK66?psc=1&ref=ppx_pop_mob_b_asin_title)

Part number match, should be good... But, No.

As you can see way smaller diameter.

Wrong part # on Eastgate? Amazon seller wrong?
Either way I trust the zip ties I have on there more than these tiny little nuts!!

FYI... Couple of the part numbers above were not for the nut....

Here is what I found... After a lot of looking haha

https://www.eastgatefordpartscanada...21-ford-fender-liner-retainer-nut-w709729s442

 

[Tbone289]

Again, realizing this is an old post but in case someone else has the same problem...

I found a part number at Eastgate as posted above ... Which looked like the nut we were all looking for.

But, no diameter listed so hard to know for sure...

Searched that part on Amazon and ended up here (https://www.amazon.ca/gp/aw/d/B0H1DGTK66?psc=1&ref=ppx_pop_mob_b_asin_title)

Part number match, should be good... But, No.

As you can see way smaller diameter.

Wrong part # on Eastgate? Amazon seller wrong?
Either way I trust the zip ties I have on there more than these tiny little nuts!!

Just add a thin "fender" washer to that...

Sponsored