Turn the ignition on but don't start the engine? (Per owner's manual)

[robertlapp]

So, the instructions for turning off the seat belt warning on a 2024 Lariat per the owners manual, page 48 is: "Turn the ignition on. Do not start the engine" How do you turn the ignition on and not start the engine with a "Push Button Start"?

Sponsored

 

[Exranger]

Just push button without foot on brake

 

[robertlapp]

Just push button without foot on brake

Thank you!

 

[Bob828]

I tried page 48 without any results. If the procedure works for you let us know.
Thanks

 

[Rcrew]

Read 48 too. Will be trying this today or tomorrow, hope it’s for the reminder, not just audio. Getting very tired of having to hit OK EVERY time I drive. And I always fasten my SB every time before starting.

Not sure if this controls just the audible warning, the Display warning , which is requiring me to click OK to clear, or what.
——————————
Page 48 procedure does zip. Will have to look into getting forescan as some later comments suggested.

 

[EONR24]

The procedure doesn't work on most Mavericks with the 4 inch cluster. Forscan is the solution for disabling the annoying seatbelt screen and chime. I disabled it completely. So much better.

 

[EONR24]

Read 48 too. Will be trying this today or tomorrow, hope it’s for the reminder, not just audio. Getting very tired of having to hit OK EVERY time I drive. And I always fasten my SB every time before starting.

Use forscan

 

[EONR24]

Read 48 too. Will be trying this today or tomorrow, hope it’s for the reminder, not just audio. Getting very tired of having to hit OK EVERY time I drive. And I always fasten my SB every time before starting.

https://www.mavericktruckclub.com/f...n-confirmed-working.45892/page-11#post-872738

 

[ABTremor]

Read 48 too. Will be trying this today or tomorrow, hope it’s for the reminder, not just audio. Getting very tired of having to hit OK EVERY time I drive. And I always fasten my SB every time before starting.

My hack to avoid hitting ok every time:
I fastened all three rear seat belts and leave them fastened, now when I get in and fasten my seat belt before starting there's no need to hit ok and as long as I buckle up prior to starting there's no pop up either. Of course if somebody gets in the passenger seat they also need to fasten their belt before starting the truck, if not I get the pop up and chime.

 

[Roman Canadian]

I have a way, I just open the doors at 100km/h and the belt error goes away. - don't thank me.

Sponsored