Muslogy for Maverick Trunk Bed Mat Is Available on Amazon Now! [10% OFF]

[Muslogy Auto]

I'm only interested in the pieces that go over the window switches on the front & rear doors and the small trim piece that goes on the bottom of the steering wheel.

Understand. Let me check it with the team

Sponsored

 

[Mavreezy]

Understand. Let me check it with the team

Thank you

 

[MM Mav]

@Muslogy Auto will this fit truck beds that have spray in or drop in bed liners?

 

[atenango]

I'd like to know if it fits with spray in bed liner as well.

 

[Muslogy Auto]

@Muslogy Auto will this fit truck beds that have spray in or drop in bed liners?

It shall fit. We are not sure how it fits with the spray in liner. You might wanna give it a shot. We will provide a free return for you if it doesn't fit

 

[Muslogy Auto]

I'd like to know if it fits with spray in bed liner as well.

Not sure how it fits with the spray in bed liner. I will make an update once we confirm

 

[19mustang65]

If you send me one I'll confirm for you

 

[Cubsfan24]

If you send me one I'll confirm for you

Same..I’ll be the test dummy lol

 

[AbnRgr]

I own a ‘23 XLT hybrid with a LineX SIBL. I received my Muslogy bed mat yesterday. After laying it out in the Sun for a short period to flatten creases due to it being shipped folded, I dropped it into my truck bed. I’ll leave it to you to use the attached photos and judge for yourselves the fit with a SIBL. I’m more than satisfied!

 

[Muslogy Auto]

@Muslogy Auto will this fit truck beds that have spray in or drop in bed liners?

Yea we received feedback from our customers that it fits with the spray in bed liner

 

[Muslogy Auto]

why/what are the raised horizontal ridges there for?

Those horizontal ridges are designed for preventing items or groceries from sliding and it can be folded easily to store if you don't need the mat

 

[SimplyCosmic]

Any recommendations on what to use to cut flaps into the portion that covers the in-bed anchors?

I may also drill holes in the channels up near where the in-bed drain holes are. The liner sheds water out the back when you accelerate even lightly, I just want to help with drainage after a car wash.

 

[Jelvismc]

Muslogy…why don’t you make a decent set of door sill protectors…not just a piece of vinyl stuck on the flat surface like all the rest..?…thanks

 

[Jelvismc]

Our products are made in China

Why don’t you design some nice and effective door sill protectors

 

[Muslogy Auto]

Any recommendations on what to use to cut flaps into the portion that covers the in-bed anchors?

I may also drill holes in the channels up near where the in-bed drain holes are. The liner sheds water out the back when you accelerate even lightly, I just want to help with drainage after a car wash.

A cutter or razor knife would work. One can either cut along all edges for full unimpeded access, or leave one edge uncut leaving a hinged flap, over the anchors.

The lip of our truck bed mat tapers down in height at the rear. Rather than creating a standing pool, liquids can flow out the bed at the tailgate. Jostling of the truck in motion will assist the bed’s draining.

Sponsored