- Thread starter
- #1
So it officially began today, after purchasing 3 different pairs of fog light to finally find the correct pair. Plan is to mold them have them look factory with cutout. They have fog lights and DRL in same housing. This is going to be a lot of fabrication, heating plastic and painting to get the look I am going for.
I am not sure what all fabrication will have to done by the time this is done so buy at your own risk. I also had to purchase two harnesses that I will modify to make these work the way I want.
Link to fog lights: https://www.amazon.com/dp/B07WDJ9Y5B?psc=1&ref=ppx_yo2ov_dt_b_product_details
If you got questions I will try and answer them but it is early in the fabrication.
I know the cutout looks rough right now but we will fix that.
Here is the beginning of the process so far.
Cutout for the test fit after heating the plastic to start to get it to shape up to the light. Needed to be flat against the fog light housing and it worked. Wives foot gets an honorable mention also.
First test fit of fog light, you can start to see the plan now.
I am not sure what all fabrication will have to done by the time this is done so buy at your own risk. I also had to purchase two harnesses that I will modify to make these work the way I want.
Link to fog lights: https://www.amazon.com/dp/B07WDJ9Y5B?psc=1&ref=ppx_yo2ov_dt_b_product_details
If you got questions I will try and answer them but it is early in the fabrication.
I know the cutout looks rough right now but we will fix that.
Here is the beginning of the process so far.
Cutout for the test fit after heating the plastic to start to get it to shape up to the light. Needed to be flat against the fog light housing and it worked. Wives foot gets an honorable mention also.
First test fit of fog light, you can start to see the plan now.
Sponsored