Engine cover & DIY strut tower brace

[Max George]

To All
I enjoy creating and fabricating.
.065 SS Brushed SS tubing
LH and RH lathed ends 316SS
55MM M8 Bolts
LH & RH Aluminum Hiems
1" Diameter Aluminum Spacers (1" spacer tall between bottom of Hiem overall 1 3/8 with step)
Mike and I must have similar visions.
Some pictures of my Mavi
I also purchased a non-hitch filler plate from Ford and modified to fit, much cleaner.
H&R super sport springs and Steeda Sway, Handles great.
It's not a GT4

Sponsored

 

[Max George]

Mike
Nice work, where are you using the flat plate that you laid out and made.
I don't appear to have any clearance issues.
Max

 

[first_ford]

Tried something different used 2 emblems. I had to build up the cavity with 3 pieces of 3M tape that got the emblems level I added some trim adhesive just for good measure.

 

[Me B]

Hi Max, With the strut bar installed the round black thingy and the flex hose would rattle against the strut bar pulling my 19' Lance travel trailer. I had to also trim the engine cover around the black thingy. Your 2.0 badge is nice!
Mike

Sponsored