that's when you made a mistake and destroyed the engine, or at least that cylinder. you didn't say when it first set a code. when that happened you pull over, tow it, and maybe the engine is already gone or maybe you can save it. I'm saying this more for everyone else's benefit and yours next time. do not reset a misfire code and keep driving. do not replace a melted or otherwise damaged plug and keep driving.on the way home after 30 minutes into my drive it started missing and running on 3 cylinders. I pulled over and let it sit. Checked the codes and it another out babies it back home and 10 minutes away it would barely run over 60 in eco mode babying it
spark plugs at this power level are never the issue in my experience unless you have the heat range wrong which causes detonation.
possible other causes:
bad fuel. not enough fuel, especially if running high ethanol on a standard 93 e10 map.
dirty or failed injector.
aggressive map with too much timing and/or lean afr.
.. and a lot of other possible causes you have to tear down to check out.
Sponsored