Slamologist slammed Area51 (lowered on Escape springs)

[SLAMOLOGIST]

@SLAMOLOGIST Before I start snapping clips off, any tips or advice on getting the Crown Vic center caps on? I assume it's as simple as gently moving the clips appropriately until there is a snug fit onto the steel wheel?

I know there is a little gap on 3 of mine. The 4th one is snug against the wheel.

Sponsored

 

[Tug Toy]

Lookin sharp!!!

 

[Ford Motor Company]

Been lurking since last July . Finally signed up. Here’s my Area51 XL Fwd .H&R Escape springs , trimmed bump stops. Blacked out wheels with interceptor hub caps. Roll up hard cover. Steeda bov mod . Added non xl factory things, Bed cubbies, tailgate lock actuator, cruise control.

What a beauty! We hope you are loving your Maverick! Thank you for being a part of the Ford family.

 

[NLGreaseMonkey]

What lug nuts are needed for the Police caps to snap onto? Where did you source them? Thanks!

 

[AMCfoxbody]

What lug nuts are needed for the Police caps to snap onto? Where did you source them? Thanks!

I used the same center caps so I can chime in here. I used the OEM lug nuts from the XL steelies. You need to slightly bend the tabs on the inside of the interceptor caps to fit but it's very snug and fit with no problem.

Sponsored