InvisiBrake Installation for flat towing?

[Mr.Toad]

Hello Everybody, has anyone had this installed? Could really use a picture of the vacuum line tie-in.

Sponsored

 

[Vongreg]

No tie in. The Invisibrake is similar to the Stay & Play which I installed. The Maverick has an electric brake booster so no vacuum lines. From the install instructions.

Note: The vacuum line is used on vehicles with a typical vacuum-assisted power brake system (Figure 13). If the vehicle is equipped with a full-time or “ac- tive” power braking system, in which the vehicle has full power brakes with the ignition switched off, it will not be necessary to install any of the components in this section. Leave the vacuum port as is and proceed to the next section, “Check the existing lighting”.

Need any help PM me. It’s been a few years since last installed an Invisibrake but would e happy to help. Also the folks at the Roadmaster help desk are down right fantastic.

 

[Mr.Toad]

Thank you so much!

Sponsored