Ignition Switched Power BCM #3 Fuse

[schueltar]

I have a 26 EB Lariat.. the bcm was giving me fits, I wanted an ignition switched power source to turn a relay on so I wouldn't have to remember to shut my Ham Radio off... (running battery to relay, then to radio) the only switched source I was positive on was 6, (moonroof) but the tap in there didn't fit. #3 in the 26 is also ignition switched.

Sponsored

 

[BK007]

I have a 26 EB Lariat.. the bcm was giving me fits, I wanted an ignition switched power source to turn a relay on so I wouldn't have to remember to shut my Ham Radio off... (running battery to relay, then to radio) the only switched source I was positive on was 6, (moonroof) but the tap in there didn't fit. #3 in the 26 is also ignition switched.

This may help

https://www.mavericktruckclub.com/f...se-box-diagrams-specs-bookmark-this-🛻💨.83327/

 

[schueltar]

This may help

https://www.mavericktruckclub.com/forum/threads/interactive-fuse-box-diagrams-specs-bookmark-this-🛻.83327/

That goes up to '25 from what I saw. I found one that is unused according to the owners manual and most micro2 fuse taps will fit in.. its #3. I just want to let others that have a '26 that might need an ignition switched fuse know of what i found.

 

[Mabcim]

Used #3 in my ‘22 and my ‘25; not issues at all. For same reason, tap doesn’t fit in #6.

 

[801Maverick801]

If you are good with Pins, you can add a pin on the output side of the fused circuit you want to use. I did it when I added Adaptive cruise control (power feed for the radar) red wire in the photo is what i added.

Sponsored