Fibrobec E-Vision ~ Flat Top Bed Cap for Ford Maverick

[Xjeepguy]

Sponsored

 

[Xjeepguy]

I think its a pretty nice fit, not the tallest but ??

 

[Yellow Rhino]

A few questions:
Did they colour match the topper for your Maverick?
How much did it cost?
Is this their E-Vision topper?
How long did it take for you to order and receive?

 

[MaverickQC]

Here is a beautifull bed cap!!

 

[triangulumhalohydra]

Looks great! Lots of questions:
- How much was it?
- Easy to install? Anything more than clamping it on?
- How's the weather resistance? Does it keep water out better than my crappy Ford folding tonneau?
- Where can we order?

Thanks for posting!

 

[MaverickQC]

3600 Canadian dollars installation inclued. Its only clamp. And im not sûre about weather/water résistant. If it leaks from the bottom of the cap, i Will put some silicone under IT. I know that on the plastic rails on the bed There are some Deeper sections that may leaks. Front corners and about 10inch from the front each Sides.
The dealer that install them is garage Charles Turcotte Point-S in Québec!

 

[TedTX]

Fits well

 

[greenweever]

Is this the same as an ARE V series?

 

[MortyHooper]

Nice to see a vid from Quebec! You described and showed it really well. Your all black look is good.

 

[MaverickQC]

I ain't sure about it. I dont know so Much About them

 

[Mike D.]

I think its a pretty nice fit, not the tallest but ??

Have interest in your lightbar install. Did you go thru facia into actual bumper, any spacer to support lightbar brackets? You didn't cut anything... did you? My truck definitely needs help in lighting up the roads I drive in northern Michigan. any help or direction or shoulda dones' write back. Thanks Mike D. great cap !

 

[MaverickQC]

Here is my DIY video Mike!!

Tell me if you have questions. I had to Cut my bumper A Little bit.

Sponsored