Bed Cubby Door part number : NZ6Z-60286A72-A

[MavrickEcoBoost]

Got it so your part is just the cubby.

It should be the whole assembly but ill check it tomorrow when on the computer.

Sponsored

 

[Lappo424]

It should be the whole assembly but ill check it tomorrow when on the computer.

You're the man. Thanks bro

 

[MavrickEcoBoost]

You're the man. Thanks bro

Yes the part I gave is the entire assembly. Cubby and door. When you take off the screws for the panel youll need to keep those as it is the same screws needed for the cubby.

 

[Lappo424]

Yes the part I gave is the entire assembly. Cubby and door. When you take off the screws for the panel youll need to keep those as it is the same screws needed for the cubby.

Thank you sir
When do you think it will be available for purchasing?

 

[MavrickEcoBoost]

Thank you sir
When do you think it will be available for purchasing?

There is really no telling. They show stock now at Ford but it isnt priced. So that would tell me that they are keeping them for units that could have warranty issues. Id say when they start hitting the ground in November they should be good to go.

 

[MavrickEcoBoost]

Any idea on the floor bed d rings? @MavrickEcoBoost

It is the same scenario as the cubby, Here is the part # NZ6Z-60550A74-A. Ford shows them available as well but not priced. So these would be for warranty units as well until parts are given the green light.

 

[Lappo424]

It is the same scenario as the cubby, Here is the part # NZ6Z-60550A74-A. Ford shows them available as well but not priced. So these would be for warranty units as well until parts are given the green light.

Thanks. I owe you. Can you look up the number for the bed rails that are in the xlt and up?

 

[Cubican]

I called the Ford dealer they couldn’t find it so make sure to provide the part # for them.

 

[Nw_adventure]

That plastic cubby cover is flimsy AF - Will probably break within a year or so when dealing with Sun /Cold - UV rays. Probably not that hard to make a much beefier unit though.

 

[Lappo424]

@MavrickEcoBoost Hi there sir. I have an xl and I was looking to see if you could get the factory self tapping screws for the bed. I want to add the bed tie down anchors and the d ring hooks near the upper part of the tail gate. I went to lowes and depot no luck.

 

[Cubican]

Just order the bed cubby and at 65 buck I think is a bargain plus I used my ford points

 

[Lappo424]

Just order the bed cubby and at 65 buck I think is a bargain plus I used my ford points

Is it available now?

 

[Cubican]

Yes it is but the parts guy had a problem finding it so be sure to supply the part # for them. It took few weeks to get here

 

[mcc63303]

I just installed two cubbies (Ford part lists them as "Partition") in my XL.
Ford part # NZZ-60286A72-A as noted in thread listing. List price is $40 each, dealer sold them to me at $33.60 each plus tax. Both sides are the same.
You have to remove the "tie-down hooks" to install the cubby. Cubby has holes for 6 bolts, threaded holes are in the bed for the other two, the covers only have 4 bolts.

 

[kcamp317]

I ordered one at my dealer the other day and it came in fast. And the 2 extra bolts....W505424-5450B.

Sponsored