Maverick bed anchors D-rings?

[IndyPaceCar327]

My XL did not come with any bed anchors.
Does anyone know of any D-rings that are a good fit with minor modifications or direct fit other than the OE parts?

Thank you.

Sponsored

 

[paneubert]

These reportedly have good hole spacing.

https://www.amazon.com/gp/product/B00C5RME3C

And these bolts (for the floor of the bed)

https://www.amazon.com/gp/product/B01M01EQ2W

These are the ones for the "cleats" that are up near the top bed rail near the rear window and the top of the tailgate

https://www.amazon.com/gp/product/B01E5CFA1W

 

[TheWizziard]

If you are looking for anchors for the floor of the bed, this video not only has a link for the anchors but also instructions for installing them.

Note: the XL has the holes but they are not threaded.

 

[IndyPaceCar327]

These reportedly have good hole spacing.

https://www.amazon.com/gp/product/B00C5RME3C

And these bolts (for the floor of the bed)

https://www.amazon.com/gp/product/B01M01EQ2W

These are the ones for the "cleats" that are up near the top bed rail near the rear window and the top of the tailgate

https://www.amazon.com/gp/product/B01E5CFA1W

Thank you very much for the info.

 

[IndyPaceCar327]

If you are looking for anchors for the floor of the bed, this video not only has a link for the anchors but also instructions for installing them.

Note: the XL has the holes but they are not threaded.

Thank you very much for the info.

 

[IndyPaceCar327]

I ordered the anchors on Amazon.
They came in a day later and installed them tonight.

They will do the job.

Thanks for the help.

 

[Maverick2023]

I ordered the anchors on Amazon.
They came in a day later and installed them tonight.

They will do the job.

Thanks for the help.

remember to tap them holes....not the stripper holes.

 

[upnash]

Why wouldn’t you call the dealer and order the correct parts?

 

[yoyomav]

I just did it by following the video. Only tip is to get a good M8 tap. I was using some crappy tap from a cheap set and I almost broke it in the hole. Switched to a new tap and it went in like butter.

 

[IndyPaceCar327]

I just did it by following the video. Only tip is to get a good M8 tap. I was using some crappy tap from a cheap set and I almost broke it in the hole. Switched to a new tap and it went in like butter.

I have an Irwin metric Tap set and the task went very well.

Again thanks for the help from everyone.

Sponsored