Nicely done! I'm leaning more toward this dibl than a sibl the more I see of it.Here is my installation of the Ford Accessories drop-in bedliner step-by-step with a couple of small changes.
There were outlines and cutouts could be done but I chose not to cut them out for a cleaner look. The only power accessory I had planned was the outlets at the cubby panel and that was done prior to installing the bed liner. You can always pull the panel back off in a few minutes to get to the 12V power source if you want to add something later.
Are those your factory tie downs or replaced? They’re different than mineHere is my installation of the Ford Accessories drop-in bedliner step-by-step with a couple of small changes.
Oh i did see that thread. Didn’t realize it was the same poster lol so why are those better than factory ones?
They function the same but cost about 6% what the factory ones do.
It was explained in the video......
XL has no bed floor mounted D-rings or tiedown points. There are however 4 tie down cleats mounted a little bit higher in corners of the bed.
