Tweeter and door speaker crossover

[BeardedMarine]

While I'm adding sound deadening to the doors I figured I'd swap out the coaxial speakers for components. Question I have is where are you putting your crossovers?

Sponsored

 

[nobbyv]

On mine, the crossover was built into the woofer, but I'd say there's plenty of space to tuck a small crossover box in the dash under the tweeters.

 

[papawmark]

I have HUGE crossovers with my Polk Audio DB series component speakers. I only hooked up the tweeters to the crossover and somehow got it down past the door pillar and between the side dash and below the pillar. Don't know if I can get them out to change tweeter jumper settings if I ever wanted to. Anyway, I didn't hook up the door woofers from the set, shouldn't need to since I am installing a dsp.

 

[BeardedMarine]

On mine, the crossover was built into the woofer, but I'd say there's plenty of space to tuck a small crossover box in the dash under the tweeters.

I found a place behind the glove box. Thanks for the reply.

 

[BeardedMarine]

I have HUGE crossovers with my Polk Audio DB series component speakers. I only hooked up the tweeters to the crossover and somehow got it down past the door pillar and between the side dash and below the pillar. Don't know if I can get them out to change tweeter jumper settings if I ever wanted to. Anyway, I didn't hook up the door woofers from the set, shouldn't need to since I am installing a dsp.

Yeah these are huge also. I did the same and just used the crossover for the tweeters since I have an amp doing the crossover business for the door woofers.

Sponsored