Remote start using fob key does not start 2024 XLT hybrid temperature at 19 F

[ncoelho]

Remote start using FOB key does not start 2024 XLT hybrid on low temperature at 17 F
had to use fob key for manual start

Sponsored

 

[HeyBales]

Was that a dealer add-on?

You should ask them about that, since the 24MY didn't have that as an option - unless it came with a Lux package.

Because it can be physically remote started just fine - proved by remote start through Fordpass app will work.

 

[Hot Runr Guy]

Just for kicks, make sure you press the door lock button first, before you try to remote start. For some reason, mine seems to want confirmation that the doors are locked first.

HRG

 

[Maverick Country Club]

Just for kicks, make sure you press the door lock button first, before you try to remote start. For some reason, mine seems to want confirmation that the doors are locked first.
HRG

I have always pressed the and then ((2x)) twice when using the remote to remote start, but your comment makes me wonder what happens with the doors left unlocked and a scheduled remote start programmed with the Ford App…

 

[ncoelho]

mine is a 2024 XLT Hybrid lux package
start worked with key in ignition with a 20-minute run , following that fob start worked pressing lock + x 2
I try not to use ford pass remote start because it has been known to drain the battery and have experienced dead battery at 5000 miles

 

[HeyBales]

mine is a 2024 XLT Hybrid lux package
start worked with key in ignition with a 20-minute run , following that fob start worked pressing lock + x 2
I try not to use ford pass remote start because it has been known to drain the battery and have experienced dead battery at 5000 miles

Regarding Fordpass app so you have correct info.

Unless you removed fuse 11 - your truck every time you park - is reporting up to Ford servers some stats.
And it keeps the network connection up for potential remote access by pinging the network hourly. No data sent.

You using the app to talk to Ford's servers doesn't effect that at all. It's happening no matter what.
Unless you are looking constantly using app, and requesting an update of location each time.
Only if you perform an action requiring the truck to do something - lock/unlock doors, remote start - would the truck actually be involved - that's why there is a delay. App talks to Ford servers, servers talk to truck, action reported back to servers, back to your app.
You looking at the status does nothing with truck.

You got a dead battery for other reasons - unless you have terrible ATT service where truck is parked, and it kept getting into bad loop of trying to upload data on parking, and have now removed fuse 11.

If you have not - and still have Fordpass app installed - it IS a valid test of ability to remote start when it's cold. Because it uses most of the same system. Except the radio receiver for the fob. 1 test start is all.
That would narrow the issue down, in case you have to take it back in for troubleshooting, then they can focus on where likely issue is.

 

[HeyBales]

I have always pressed the and then ((2x)) twice when using the remote to remote start, but your comment makes me wonder what happens with the doors left unlocked and a scheduled remote start programmed with the Ford App…

Interesting test, if it causes the same action.

USING REMOTE START

WARNING: Do not start the engine in a closed garage or in other enclosed areas. Exhaust fumes are toxic. Always open the garage door before you start the engine. Failure to follow this instruction could result in personal injury or death. WARNING: Do not keep electrical devices plugged in the power outlet whenever the device is not in use. Power outlets power up during remote start.

The system allows you to remotely start your vehicle to heat or cool the interior to a preset temperature.

1. 
   Press the button on the remote control.

1. 
   Press the button twice within a few seconds.

When you successfully remote start your vehicle:

• The vehicle doors lock.
• The turn signal lamps flash twice.
• The parking lamps turn on when the vehicle is running.
• The vehicle remains secured when you have remotely started the vehicle. A valid key must be inside your vehicle to switch your vehicle on and drive your vehicle.
• All other vehicle systems remain off when you have remotely started the vehicle.

The horn sounds if the system fails to start.
Note: You cannot adjust any comfort settings until you switch your vehicle on from inside your vehicle.
Remote start does not work under the following conditions:

• Remote start is not enabled.
• The alarm horn is sounding.
• The hood is open.
• The transmission is not in park (P).
• Your vehicle is already on.

Note: Do not use remote start if your fuel level is low.
Note: A maximum of two remote starts are allowed. After that you have to switch your vehicle on and off before you can use remote start again.

To remotely stop your vehicle, press the button.

Sponsored