- Thread starter
- #1
My Maverick included a hard trifold cover, and I am trying to figure out how to remove it and reinstall it. Does anyone have a source? I did not see anything online or on YouTube.
Sponsored
Sponsored
If you are not able to open it and look, or search the dozen YouTube videos, you should probably take it to someone capable of operating a 9/16” wrench for those (6) bolts......
To remove (only) the top folding cover but retain the mounting rails, fold it all the way up against the back truck window, loosen the (2) thumb screws, and lift it off.
The mounting rails are secured with (6) C-clamps...
.
Last edited:
- Thread starter
- #4
So I can completely remove the bed cover by unscrewing the clamps holding on the rails and yanking out the drainage tubes?
Sponsored
What exactly are you trying to do? Temporarily remove the cover but reinstall it later, or permanently remove it along with all mounting hardware?
2 thumb screws allow you to lift off the cover and reinstall later, 6 clamps removes everything permanently..
.
- Thread starter
- #7
I want to be able to do both, temporarily remove the cover to make room for cargo and maybe later remove to install on another Maverick.
I have the soft trifold cover and have the same question. Hope it’s ok to ask the question here in a similar post instead of creating a new one.
Have never taken mine off but it looks like after you fold it to the 1/3 position there is 2 clamps holding it, located near the front of the bed.
Have never taken mine off but it looks like after you fold it to the 1/3 position there is 2 clamps holding it, located near the front of the bed.
Last edited:
- Thread starter
- #9
I looked and there are two knobs at the front that I can twist by hand and clamps on the sides and two drainage tubes. I have not tried to remove yet.
I suppose if I want to move my bed cover to another Maverick, I will have to buy a new seal.
I suppose if I want to move my bed cover to another Maverick, I will have to buy a new seal.
Sponsored
