- Thread starter
- #1
Has anybody figured how to enable the rear-view camera when moving forward? Would be helpful when the rear window is blocked with bed cover or tall loads.
Sponsored
Not true [anymore]. FORscan was only needed for the FMods Jailbreak procedure to time the SYNC3 reboot just right -- pressing and holding VOL/PWR+SeekForward will initiate a reboot as well.But it needs ForScan
took a ride in my truck with the Reverse Cam FMod turned on -- camera stops showing image at 10mph or so and after a bit a warning pops up that the camera is unavailable and to contact the dealer.. when I come to a full stop that warning disappears and the camera starts showing again.. putting the truck in Reverse then back in Drive disables the OnDemand view until the VidCam button is pressed again on the screen.Washing done and go to exist slowly because blowers clear the water off truck. Now the interesting part, I placed the truck in drive and brake off, the rear-view screen comes on while going forward. Stays on until the truck moves about a third of the way out the exit and radio/audio screen comes back on with good reception.
saw a Motion Unlock For SYNC 3 & SYNC 4 Equipped Ford Vehicles harness on eBay which "unlocks" things that are blocked when the truck is moving.. e.g. entering a Nav destination while driving.. I have a strong hunch that adding this cable harness to a jailbroken SYNC3 would allow the reverse camera on demand mod to also keep working while moving forward..I figure there's gotta be a way to disable that "safety" feature (or bug?) and leave the camera operational regardless of forward speedmaybe using FORscan is required after all?