- Thread starter
- #1
Finally got my bakflip mx4 toneau cover and installed it. Got it from these guys: https://www.autoeq.ca/bakflip-mx4-ford-maverick
Lots of videos on YouTube. Will need a 14 mm Ratchet and Phillips screw driver and a punch for the drain tubes to go through grommets.
First impressions. Seals are very playable even in 2c weather when I installed it. My bulkhead was rino lined by the dealer so I used some clear silicone to glue the bulk head seal.
Down side. This cover is easy to scratch. Noticed some surface scratches already.
Lots of videos on YouTube. Will need a 14 mm Ratchet and Phillips screw driver and a punch for the drain tubes to go through grommets.
First impressions. Seals are very playable even in 2c weather when I installed it. My bulkhead was rino lined by the dealer so I used some clear silicone to glue the bulk head seal.
Down side. This cover is easy to scratch. Noticed some surface scratches already.
Sponsored
Last edited: