ALL4SPL's 23 Cactus Gray Maverick Build Log

[All4spl]

And for now its done, I will put the covers on the back seat and put it back in next weekend.

VERY impressed with these subs, the are performing very well. Not as much LOW end but that might improve as they get broken in.

Sponsored

 

[Havick]

Looks pretty sweet. I like the box, do you have a link? I tried searching google for the company you listed, but had no luck.

 

[All4spl]

Looks pretty sweet. I like the box, do you have a link? I tried searching google for the company you listed, but had no luck.

I contacted them through facebook. https://www.facebook.com/sounddecisionsbpm/

 

[All4spl]

As much as I love class A/B amps they get hot fast, so I ordered up a new amp for the mids/highs and slapped it in today.

Does 200 x 2 @ 4 ohms RMS and 325 x 2 @ 2 ohms RMS which it is currently wired down to 2 ohms. I also added around 6-7oz of poly fill to the enclosure, not sure if I will keep it in but for the cost $6 I figured give it a shot.

 

[thev8man]

I really like your black emblem lettering

 

[volksnuts]

Did you swap amps because it’s touching the seat or something?
My 4 channel RF amp barely gets hot at all (it’s the big one that uses its heat sinks the most, ugh)

 

[All4spl]

Did you swap amps because it’s touching the seat or something?
My 4 channel RF amp barely gets hot at all (it’s the big one that uses its heat sinks the most, ugh)

I was running my T400-2 at 2ohm, and because of the mounting orientation it was getting to me uncomfortably hot on the top edge heatsink. The new class D full range is at 2ohm and after a 1.5 hour drive at a very good click volume it was barely warm.

 

[All4spl]

Not much new to the truck lately I did install a new front and rear dash cam setup which is still currently on sale on amazon. https://www.amazon.com/dp/B09LLLF8PG?ref=ppx_yo2ov_dt_b_product_details&th=1

Other than that, I have decided to put the factory wheels and tires back on, since I cannot locate anyone local to do a lowering spring install. I will however be getting black lug nuts to replace the factory chrome ones.

 

[Iceman622]

Installed the DRLs from amazon that I saw on this forum, wasn't too hard of an install I was able to run the wires through a gap on the outer end of the light between the grill and headlight. I also used 3M Emblem double sided tape to install them as I did not want to drill into my grill at all. I elected not to connect the turn signal portion as I think the Lasfit LEDs do plenty for turn signals.

Truck looks great. Do you happen to have the link for these lights?

 

[All4spl]

Truck looks great. Do you happen to have the link for these lights?

Here are the ones I used.

https://www.amazon.com/gp/product/B096RSB8C7/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1

Sponsored