Subwoofer install troubleshooting

[MLC2023]

All hooked up just like I’ve read on a few posts here. The amp is tapped to the rear pillar speakers. There is sound, but not very loud. Any suggestions?
JBL Stage 82AM 8” 4 ohm
Kenwood KAC-M3001

Sponsored

 

[Superg0]

Did you check input sensitivity?

 

[MLC2023]

@Superg0 i’ll recheck. But I think it’s all the way up.

 

[Superg0]

@Superg0 i’ll recheck. But I think it’s all the way up.

Then check the LPF, it may need adjusting

 

[MLC2023]

@Superg0 yep, all the way up. Thanks for the suggestion. LPF is all the way up also. Should I adjust the LPF down?

 

[Superg0]

@Superg0 yep, all the way up. Thanks for the suggestion. LPF is all the way up also. Should I adjust the LPF down?

Yes adjust until you get the desired sound, its not all up or down

Sponsored