Mystery green plug on the driver side

[richardrickards]

Does anyone know what this mystery green plug that is dangling around on the driver side.
this is a 2023 hybrid lariat.

Sponsored

 

[paneubert]

DANG IT. I thought I was going to be able to whip out my list of "green thing" threads.



Green Tab Threads:

https://www.mavericktruckclub.com/forum/threads/i-discovered-a-pull-tab-in-fender-well.20040/

https://www.mavericktruckclub.com/forum/threads/refueling-door-wont-open.16442/

https://www.mavericktruckclub.com/forum/threads/hybrid-fuel-door-emergency-release.12942/

https://www.mavericktruckclub.com/forum/threads/what-is-this-thing.14455/

 

[BlueSpec1]

Thought I saw somewhere it's for part of High Voltage System De-energizing procedure by Ford Techs.

Connector: C1001 - Low Voltage Service Disconnect (LVSD)

High Voltage System De-energizing

2. NOTE: The use of the "Manual Depower" procedure in this section must only be used when a Ford – specific diagnostic tool is not available or the diagnostic tool procedure fails.
Using the FDRS CARRY OUT the BECM -High Voltage System De-energizing and follow the on-screen instructions.

• Detach the pin-type retainer and position the electrical connector and wiring harness aside.
• Release the Connector Position Assurance (CPA) clip.
• Depress the tab while pulling the connector until the hole is completely visible on the top of the connector.
6. NOTE: Make sure the electrical connector is secured with a cable tie when opened.
7. Using the FDRS COMPLETE the BECM -High Voltage System De-energizing and verify the high voltage system has been de-energized.

 

[richardrickards]

Nice find. it looks really tight to snap into the hole because of the wires. do you think I should attach it some other place?

 

[adamgrattan]

Does anyone know what this mystery green plug that is dangling around on the driver side.
this is a 2023 hybrid lariat.

Looks like that white plug goes in that hole

 

[BlueSpec1]

Nice find. it looks really tight to snap into the hole because of the wires. do you think I should attach it some other place?

Maybe just to keep it from hanging.
I see my Escape has slightly different layout and my connector fits into a hole.

 

[richardrickards]

I agree, but there is not enough room because of the wire harnesses. I can try and bend them out of the way, but this is very tight. thank you for your photo also.

Sponsored