Window Visor

[Mdmac]

Hello all, I want to get a set of Window Visors for my 2023 XLT. Any advice on a brand ? Also I see Tape On OR In channel Visors? Also and Beans better than the others? All Opinions are helpful. Thanks MTC crew.

Sponsored

 

[Larryhd1]

Goodyear in channel will not break

 

[Glen Baker LLC]

These are Ford OEM stick-on that have been trimmed for an exact custom fit.

Above are Maxzina in channel.
There are other brands of in you channel, weathertech, EGR .....

If you drive real close to traffic. Some tinted in channel with lower wind deflection will shade a corner of the passenger mirror. 🤏

Good luck with your search,

GB

 

[Dave O]

Maxzina In-Channel Visor Rain Guards

 

[tom_tucker]

These are Ford OEM stick-on that have been trimmed for an exact custom fit.

Above are Maxzina in channel.
There are other brands of in channel, weathertech, EGR .....

If you drive real close to traffic. Some in channel with lower wind deflection will shade a corner of the passenger mirror. 🤏

Good luck with your search,

GB

I saw somewhere that the OEM vendor meant the Ford stick-ons to be mounted much higher. Not all the way at top of up the painted surface but leaving about a pinkie finger's width of paint showing. No trimming required. I don't have them but I'd go with that plan if I was getting them.

 

[2024_xl_hybrid b&w]

These are Ford OEM stick-on that have been trimmed for an exact custom fit.

Above are Maxzina in channel.
There are other brands of in channel, weathertech, EGR .....

If you drive real close to traffic. Some in channel with lower wind deflection will shade a corner of the passenger mirror. 🤏

Good luck with your search,

GB

Those custom oem visors look so much better then the way ford designed them. What did you use to trim them? Nice job man!!!

 

[Glen Baker LLC]

Those custom oem visors look so much better then the way ford designed them. What did you use to trim them? Nice job man!!!

The picture of the stick on are from another member.
I have EGR in channel.

 

[Glen Baker LLC]

I saw somewhere that the OEM vendor meant the Ford stick-ons to be mounted much higher. Not all the way at top of up the painted surface but leaving about a pinkie finger's width of paint showing. No trimming required. I don't have them but I'd go with that plan if I was getting them.

"Tom_Tucker"
The video Below in post #9 shows the visors place in a raised position, they look better.
Most I've seen are installed like photo below.

Ford OEM UNTRIMMED
Ford OEM TRIMMED

 

[2024_xl_hybrid b&w]

Unless you can provide a photo of how the vendor intended for them to be installed. Most I've seen are installed like photo below.
In my opinion it looks terrible compared to the cut and customized ones.

Ford OEM UNTRIMMED
Ford OEM TRIMMED

I agree completely. If you butt them together, the rear visor ends in some arbitrary place between the end of the window and the end of the door. I've even seen some leave a gap between them which looks even worse. Look how they ruined this maverick. (Just past the one minute mark.)

 

[2024_xl_hybrid b&w]

The picture of the stick on are from another member.
I have EGR in channel.

Cool, thanks... I'll try to hunt them down!

 

[Flight Test]

I chose the Ford OEM visors paid with Ford points. A lot of folks don't like them, however I chose function over form. They work as advertised.

 

[2024_xl_hybrid b&w]

I chose the Ford OEM visors paid with Ford points. A lot of folks don't like them, however I chose function over form. They work as advertised.

I like them, I think they look really good. But I just wish they fit the rear window better.

 

[Glen Baker LLC]

You may want to check out WeatherTech they're a US based company.
I bought WeatherTech for previous vehicles and have been happy with them.
I bought EGR's for my Maverick because WeatherTech did not have anything on the market at the time.

 

[2024_xl_hybrid b&w]

You may want to check out WeatherTech they're a US based company.

Thanks man, I will look into that!

 

[RDRahn]

I have Well Visors on mine. They use the 3M tape and have been there for nearly three years without issue. Really like how they look vis-a vis other options. Here's a link to someone selling on eBay so you can see a picture or two of them installed: WELLvisors Premium Series Rain Guard For 22-24 Ford Maverick Visors Smoke Tint | eBay

Sponsored