Power Rear Sliding Window (OEM-ish) on 2022 XLT -- DIY Installed

[710]

and because life I STILL haven’t removed them! I SWEAR soon as I walk out of this dr office they are coming off! Way too busy ADHD and thank gawd I did my blood test yesterday

Sponsored

 

[Cancunbadlands]

Installed a motor for the Manual Rear sliding window in my 2022 XLT. Wanted to use the OEM Switch as well. Was a fun project, quite the investigative project trying to find the right connectors for Everything.

-Purchased a Motor assembly with cables from a Lariat wreck for 150$

Mounted motor with Rivnut Inserts at existing location. Added 2 standalone 5 pin relays below the motor (also with Rivnuts) to stay with the schematic. I already have ran 0 gage wire for my Inverter behind the backseat so I stole power for the load side of the relays from there.

Purchased a switch bezel from a wrecked Lariat on ebay, found the correct 6 pin molex connector on mouser to interface with the rear sliding motor switch. Ran 2 twisted pair from the switch, Pin One power input (spliced into White/Blue wire out of Pin 2 on the C22BOF connector of the BCM) to stay with OEM schematic and wired a ground to pin 6 of the molex to provide ground for the backlit switch LED. Pins 2 and 3 was a twisted pair ran to the control side of the standalone relays in the back.

The Lariat Bezel had the push to start switch port, I used that space and added a 12 Volt Accesory plug.

#fire

 

[710]

FINALLY!

 

[710]

Also performed the fire sauce Taco Bell mod this new tajin freeze, taco and cheesy Gordita crunch are on point! Get em while ya can!

 

[710]

Need to post a separate thread but just installed the software for mycal Livernois tuner and just got an email saying the tune is already ready for download and install!

Sponsored