Fender Flares that work with OEM mud flaps?

[Racin72]

Best ones to work with the oem ford mud flaps..Been looking at the rough country ones.

Sponsored

 

[Sticks]

I don't think any substantial flare could be compatible with OE mud flaps. Rough Country certainly aren't.

You might have luck with adhesive cladding like the Mabett "flares" on Amazon.

 

[rk06382]

Best ones to work with the oem ford mud flaps..Been looking at the rough country ones.

I installed the Mabett Fender Flares ($139.99) and Mabett Mud Flaps. The Fender Flares install without any drilling. I only used the plastic buttons & 3M double stick tape. This the same way the Ford Air Design® Fender Flares ($669) are installed.
From Ford website:

My Maverick:

I installed both the Mabett Fender Flares and the Mabett Mud Flaps at the same time.

I agree that Mabett Fender Flares look like they belong on the Maverick.

 

[Racin72]

I installed the Mabett Fender Flares ($139.99) and Mabett Mud Flaps. The Fender Flares install without any drilling. I only used the plastic buttons & 3M double stick tape. This the same way the Ford Air Design® Fender Flares ($669) are installed.
From Ford website:

My Maverick:

Looks great, already have the oem flaps installed and maybe try the Mabett flares, just not sure on the 3m tape?

 

[LSchicago]

I opted for a different type of "Flare" These moldings give an extra 1/4" of coverage, protecting the fender edges, and minimize the black "huge wheel well" look of black flares. Trim to fit any mudflaps as I did. USA made, $37 a roll.

 

[Headcase650]

I have the factory Ford mud flaps. The Muppet flares work with them just fine. A couple tips for installation. Trim away any tape that rides up too close to the edge of the flare. Reuse your OEM push pins as they are longer than the ones provided by mabett. Make sure you put them back in the hole they came out of as they are not all the same length.

 

[Rcrew]

I too put Mabett flairs on with OEM mud flaps. Pretty straight forward. Do pay attention to length of push pins.

Did have one or two holes that needed some encouragement ie: drilling the flap hole in a slightly off spot.

 

[Rcrew]

Here’s my installation post:

https://www.mavericktruckclub.com/f...are-back-in-stock-on-amazon.49646/post-875959

 

[Racin72]

I opted for a different type of "Flare" These moldings give an extra 1/4" of coverage, protecting the fender edges, and minimize the black "huge wheel well" look of black flares. Trim to fit any mudflaps as I did. USA made, $37 a roll.

Got a link? Looks different

 

[LSchicago]

Got a link? Looks different

Dawn Enterprises, Inc. W60118-PK... https://www.amazon.com/dp/B092RGHB8X?ref=ppx_pop_mob_ap_share

Sponsored