- Thread starter
- #1
Hey all do you know if you got the factory installed drop in bed liner if the accessory power will be able to be used or will it block it ?
Sponsored
Cool so then I assume I take out one bolt pull the liner back and take a dermal tool cut off disk and cut it off ?I had to take my side panels off and cut out the openings in the bed liner.
They don’t take the time to do it for you.
It’s marked on the backside of the panels to show you were to cut.
Can you confirm if the floor is pre-cut for the D-Rings, even if the truck doesn't come with rings? Not sure if the XLT came with rings or not, so you might not be the best person to ask if yours came with rings installed.Yes and the bolts holding the side tracks for tie downs also.
I used a body saw with a fine blade than hand filed the edges.
Do you know of the dealer will cut it out to reveal the panels?I had to take my side panels off and cut out the openings in the bed liner.
They don’t take the time to do it for you.
It’s marked on the backside of the panels to show you were to cut.
I'm sure you could ask them to do it as part of the PDI process. They might charge you though.Do you know of the dealer will cut it out to reveal the panels?