Clamber Roll Bar

[Shorembo]

I recently installed the Clamber roll bar that I purchased off Amazon and thought I would upload some photos for anyone who was curious what it looks like. The bar is attached over my drop in bed liner via the clamps that come with the kit. The clamps are not perfect. Each clamp is held to the bed via two screws, but one of the clamps gets in the way of a bump in the bed. So on that clamp I used only one screw. Even with that it seems very secure and I shook it violently to make sure. Tonneau cover fits nicely. This is purely for cosmetics, but maybe when I go camping I will attach some molle water canisters to it.

Sponsored

 

[Shorembo]

Thanks! It almost looks like the IIRENO roll bar has end caps that would prevent the cover from sliding under. Could be removeable? Or maybe I am just seeing a bad angle on it.

 

[Ford Motor Company]

I recently installed the Clamber roll bar that I purchased off Amazon and thought I would upload some photos for anyone who was curious what it looks like. The bar is attached over my drop in bed liner via the clamps that come with the kit. The clamps are not perfect. Each clamp is held to the bed via two screws, but one of the clamps gets in the way of a bump in the bed. So on that clamp I used only one screw. Even with that it seems very secure and I shook it violently to make sure. Tonneau cover fits nicely. This is purely for cosmetics, but maybe when I go camping I will attach some molle water canisters to it.

It looks great! Thanks for sharing your Maverick with us.

 

[Shorembo]

I added some vintage Maverick emblems to the roll bar...

 

[TwuckHappens]

How stable/strong is this? I really like the way it looks

 

[Shorembo]

So far so good. No problems.

 

[Spottyatbest]

I ordered the same rack today! How is it holding up after a couple months?

 

[Shorembo]

So far so good. Haven't had any issues.

 

[Aguy]

Looks cool man..no complaints here

 

[Yoshienrique]

I was thinking about getting something like this but I have a hard folding bed cover and I worried if I would be able to fold it up all the way or if it would get stopped by the angle headed towards the 3rd brake light. Is it angled towards the inside?

 

[Shorembo]

My soft cover does get stopped on the third fold... aka i cannot fold the cover all the way in and snap it close. However, this has not been an issue for me personally.

 

[yeahiguessman]

Looks great! How is it holding up after a year? Any rust issues?

 

[Cancunbadlands]

Looks great! How is it holding up!

 

[Shorembo]

Still holding up great. No rust and no rattles.

Sponsored