Search results

Full disclosure... I keep my music loud. I'll have to check next time I am out and about.

Still holding up great. No rust and no rattles.

My soft cover does get stopped on the third fold... aka i cannot fold the cover all the way in and snap it close. However, this has not been an issue for me personally.

I did not think it was too hard. I watched some video's on installing dash cams on the maverick and they helped out.

I have the VIOFO A229 Pro 3 channel installed via the hard wired kit. Great camera. It is a bit sensitive, as it will take snap shots if I close the door too hard, or it will do the "save event" video if i hit a pot hole just right. After two previous dash cams (cheaper) failed me when I...

So far so good. Haven't had any issues.

I am not sure what a reserved hole is. It's just the DIBL makes the space too narrow for the front panel to fit in there. Since the DIBL decreases the width of the bed by about an inch or two. I am sure its not an issue with the spray in bed liners.

Might want to note that the front molle panel does not work with the Ford drop in bed liner. It just doesn't fit. I had to remove my bed liner to install the front panel.

So far so good. No problems.

I got the clamber roll bar off Amazon. Looking at the roll bar, and looking at the cab spoiler, I don't think it would fit. So you could mark that one off the list of possibles.

Did you have to drill into the cab? I am having a hard time figuring out how to get the wiring inside... other than maybe through the cargo bed maybe?

How did you route the wiring for the roll bar lights?

I added some vintage Maverick emblems to the roll bar...

Thanks! It almost looks like the IIRENO roll bar has end caps that would prevent the cover from sliding under. Could be removeable? Or maybe I am just seeing a bad angle on it.

I recently installed the Clamber roll bar that I purchased off Amazon and thought I would upload some photos for anyone who was curious what it looks like. The bar is attached over my drop in bed liner via the clamps that come with the kit. The clamps are not perfect. Each clamp is held to...