Search results

You still need to hand wash or agitate the surface to remove the contaminants on your paint. I pressure rinse, foam and let it sit to allow time for the chemicals to do its thing, 2 step wash and rinse, pressure rinse and dry. Even with a high quality ceramic coating, you’ll still need to...

I personally use Adam’s Polishes clay bar mitt for $29. You must use a lubricant like a detail spray or my preferred method, car shampoo/soap lightly sprayed onto the truck after it it’s initial wash and rinsed with a foam cannon. Don’t use heavy pressure on the mitt or you could incur...

This is gonna be good

I need to replace my ‘22 Lariat Lux windshield too. Can anyone of you PM me what it cost either through insurance or 3rd party for an OEM windshield? I’d greatly appreciate the advice.

Please explain

This World is upside down….

I emptied my dirty side at 800 miles was it was 3/4 full and mostly water vapor, no oil. My driving consists of 90% freeway at 2K RPM under a very light load and average traffic heading home. I work in Denver, CO at an altitude of 5280’ with low relative humidity. I’m not overly concerned with...

This mod seems to be mainly for a reduction in rotating mass inertia and parasitic drag associated with the balance shafts being driven by the crankshaft. What no one talks about are what is the effect on bearing life/wear when you remove this balance shaft.

Ordering the dirty side kit then the clean side at a later date. I have received my wife’s 2.7L Bronco’s billet oil pan plug and it’s very well machined. I’m expecting the same on this catch can. Also, UPR has been fantastic with automated order updates.

I installed mine this morning and it’s a basic job aside from having zero clearance on the inside bolt closest to the intake. If I were to do it over again, I’d remove the rubber hose that the BOV is located in and bolt it all up on my bench. Install then would only be compressing the hose...

I’ve spoken to Paragon when the Maverick was announced and a year after I took possession of mine and they still have no plans to make a cover. Sad.

Are you 12?

If I Reset the counter and hit the freeway immediately up to 75mph I can average 30-31mpg using Premium gas. This at 5,400’ elevation in Colorado in a loaded Lariat 4K/Lux Ecoboost.

Nothing obvious about that.

WTF is a “vane” on an engine?

Did you check these things immediately after you had driven the car and the engine was still warm? Your fluid levels will be low as it’s being circulated through the oil and cooling system.

Tuxmat. If they don’t have the set for a Maverick in stock, search for the Bronco Sport version for the Fronts only. It’s the same design and that’s what I bought first and then purchased the Rear set for a Maverick.

-2000 DA. That’s huge.

In CO it’s required, but luckily my dealer didn’t install the bracket before I took delivery. I still don’t have a front plate and it looks awesome without it.

Toyo AT3’s in 245/65/17 look aggressive and has fantastic ride quality on my FX4.