- First Name
- Sam
- Joined
- May 2, 2024
- Threads
- 27
- Messages
- 149
- Reaction score
- 363
- Location
- California
- Vehicle(s)
- 2017 Super Duty 2024 Maverick
- Engine
- 2.5L Hybrid
- Thread starter
- #1
This may have been discussed and posted here in the past if so sorry for the repeat but here it is again..
I was in the hunt for some additional bed cleats for my bed rails but didn’t want to lay down a Franklin for a set of factory ones so surfing the net I came across these on the web and of course found them on Amazon less than $16 all in for the set of 4 delivered…
These were made of aluminum and it looked like they would work out so I ordered them, and after a trial fit it looked I would have to do a little trimming to make them fit into the rails I took a little over .030 off each of the bosses on each side and they fit perfectly..
Here they are installed in the bed, they slide down the bed rail nicely and tighten with a just 12mm bolt… 2 at the rear and 2 at the front…
I was in the hunt for some additional bed cleats for my bed rails but didn’t want to lay down a Franklin for a set of factory ones so surfing the net I came across these on the web and of course found them on Amazon less than $16 all in for the set of 4 delivered…
These were made of aluminum and it looked like they would work out so I ordered them, and after a trial fit it looked I would have to do a little trimming to make them fit into the rails I took a little over .030 off each of the bosses on each side and they fit perfectly..
Here they are installed in the bed, they slide down the bed rail nicely and tighten with a just 12mm bolt… 2 at the rear and 2 at the front…
Sponsored