The black accents give it a great look! Your Maverick looks awesome.I really like the black accents, flares, lettering and trim on a white truck. I'm quite suprised at how it seems to clean up with just a rag, and doesn't seem to need polish or coatings or anything else to keep on easily looking good.
So if it gets wet from rain, etc. is that why you will get codes; pre collision not available, service engine immediately, check engine light ??? because where I live its rains a lot in the fall season and my Maverick did this just the other day, barely made it home.....BECAUSE SAWZALL!
couple sharp blades,masking tape to follow for a straight edge ,sanding block to finish edges . And a 7mm on a screw gun to remove some plastic cover on passenger side and a few fender liner screws close to cut line .
i used the factory line in the bumper cover to follow all around .
everything below that is all lightweight plastic and cheap abs plastic backer .
brings the real metal (reciever hitch) to become the new low point . Increasing departure angle to what it should have been .I also unplugged and rerouted license plate light wires and passenger light wires to more protected area and used tiewraps to hold them .a Lot of factory harness on these are not put in safe areas when using them for off roading . I mean the Ecu is in lower front wheel well with the connectors and engine harness literally 10” of of roadway ! Perfect for deep puddle drowning .
I already relocated my Ecu up next to fuse box in engine compartment . Over 35” above road ,water and mud .
stock Ecu location
new location
all the harness reach and grounds land on factory ground bolts .just rerouted.
Possibly , though most pre collision stuff based off of camera in windshield , but may coordinate with ecm in front too . Most all other modules are connected via a blu/white twisted pair can bus circuit that does all communications between all the modules , so if that goes down and has comm issues , no telling when or what goes down in parallel with it . Kind of sad but that’s how all modern harnesses are wired now , all manufacturers.some like bmw and Mercedes have stepped up to fiber comm lines now , because can bus is such an antiquated way to communicate , but for most applications it works fine.
Your Maverick looks stunning. Thanks for sharing with the forum!Latest additions to 22 hybrid maverick. Raptor grill,
Air Design vent cover, Rival skid plate.
Looking good, Todd! Wishing you are enjoying your Maverick to the fullest. Thanks for sharing!I installed the EGR in channel vent visors this evening when I got home.
So cool to see your Maverick in action, thanks for sharing!Yep, Oxford White 2024 Lariat doing what I bought it for
Your Maverick looks great, Steven!Here is my 2024 lariat maverick.
- Silver coil overs
- air Design front spoiler
- Ford tailgate soiler
- Tinted amber front lights & tail lights
- black vinyl emblem with white letters
- Konig Rims with falken tires
- Diode Dynamic fog lamps
- Painted all lower trim to match the truck & center windows black to match the tinted glass.
Thank you!
