TEST # 1: How long does the 12V power in the bed run after the key is pulled out

[EONR24]

Tha

Thanks I’ll check it out. I was gunna see if the switch led light next to the inverter was powered constant. If that’s the case I could rob 12volts there. It’s only powering two let strips

So you have the factory bed light and inverter? I would definitely just pick up the 12v off of that light then. Much easier lol

Sponsored

 

[ElectricCity8]

So you have the factory bed light and inverter? I would definitely just pick up the 12v off of that light then. Much easier lol

Yes. I just haven’t checked to see if that was constant yet lol.

 

[EONR24]

Yes. I just haven’t checked to see if that was constant yet lol.

It is constant I Believe but it is controlled by the switch in the rear and the one inside the Maverick next to the headlight switch. I think the cargo lights automatically disable above 15mph too! The nice thing about wiring to that bed light is that it comes on automatically when opening the door or unlocking the vehicle.

 

[ElectricCity8]

It is constant I Believe but it is controlled by the switch in the rear and the one inside the Maverick next to the headlight switch. I think the cargo lights automatically disable above 15mph too! The nice thing about wiring to that bed light is that it comes on automatically when opening the door or unlocking the vehicle.

I have them wired to a prop switch. When I open the cap they come on

 

[EONR24]

Yes. I just haven’t checked to see if that was constant yet lol.

Here's a link below to info about wiring into the cargo lights or that PIN 69 for constant 12v. The last 3 pages of this thread I linked has a lot of good info about tapping into the BCM for power!

https://www.mavericktruckclub.com/f...rket-under-rail-leds.7570/page-12#post-774327

 

[ElectricCity8]

Here's a link below to info about wiring into the cargo lights or that PIN 69 for constant 12v. The last 3 pages of this thread I linked has a lot of good info about tapping into the BCM for power!

https://www.mavericktruckclub.com/f...rket-under-rail-leds.7570/page-12#post-774327

Thanks for the info. I appreciate it!

 

[EONR24]

Thanks for the info. I appreciate it!

No problem! Here is a link to the TOUCHLINK install instructions. This may be helpful too!
https://www.fordservicecontent.com/...cessory_files/VNZ6Z_13E754_A_Bed_Lighting.pdf

Sponsored