Small Query

[WannaMav]

Rear license plate: attached by 2 or by 4 screws?

Front license plate: same question.

Went down an internet rabbit hole looking at license plate frames last evening. Know full well I'll be able to check this when bring the new truck home on Monday but thought some others patiently waiting might be curious.

Sponsored

 

[Rob Cactus Gray]

I believe it’s 2. Most of my cars could be attached by 4 but they have had 2. Probably depends on dealer. Some one who has there truck will verify shortly.

side note - there are plugs for the license plate holes .

 

[LelandJ]

Mine is 2 on the top. I only have a rear plate.

 

[Rob Cactus Gray]

Found a front plate photo. It is the top 2 as there is no where to fasten the bottom ones. The rear goes into the plastic bumper so if you wanted to put 2 more holes in you could.

 

[WannaMav]

Found a front plate photo. It is the top 2 as there is no where to fasten the bottom ones. The rear goes into the plastic bumper so if you wanted to put 2 more holes in you could.

Thank you. Contemplating these to complement my Area 51. Will have to do some careful measuring first to ascertain whether they'll fit that backing slab in the front, and also the recess on the rear bumper, without looking slapdash.

 

[GreenLady]

Thank you. Contemplating these to complement my Area 51. Will have to do some careful measuring first to ascertain whether they'll fit that backing slab in the front, and also the recess on the rear bumper, without looking slapdash.

Thanks for that link! I like those plate frames!

 

[SkeeterB]

I'm sure you like them, but, I'm not partial to them. Happy motoring when you get your Mav.

Sponsored