Roll N Lock leaking

[loopy]

Does anyone have any installation tips for the Roll N Lock M-Series. I can’t get it to seal around the canister. The spray in bed liner is on the top of the bed by the rear window, Im not sure how that affects it’s ability to seal. I have the ends of the side rails contacting the tailgate as instructed, but I’m not sure if that pulls the canister too close to the rear of the truck.

Also, does anyone have pictures of their hardware to clamp the rails on. I’ve got it attached, but some of them don’t seem to have much room to clamp as intended.

Thanks in advance for any help or guidance.

Sponsored

 

[flatLander]

When I did my install that is exactly what happened. I ended up going to a local home depot or lowes and found some rubber weather stripping to help stop the leaking. It mostly worked and just have a little at each of the four corners now. I just stuffed it in along the front, but ultimately I am going to raise the canister and put the weather strip on the canister and then set the canister again.

The biggest problem I have is having to shim the rails up at the back to get the tailgate to close smoothly. As mentioned the realTruck installation and their support people say you have to shim and the amount in the install guide was not nearly enough for mine.

I will get a picture of the weather strip I used and upload that.

HTH