Ender 3 V2 help?

[MaverickAngler]

Hey all, I hope this is an okay place to look for help here.
I recently picked an Ender 3 V2 and it was doing pretty decently but I was having some small issues with bed adhesion. I bought a BLtouch and that’s when my problems began
My printer will not do maybe 20 layers if I had to guess and then the extruded lifts up roughly 1/2” above the item and just continues on moving it’s head the way you’d expect to be. No filament feed but just keeps moving along as it should.
This happens on multiple items.
Please help!

Sponsored

 

[Darnon]

Is it actually just randomly moving up and stopping filament feed or just failing to extrude properly (jamming)?

 

[MaverickAngler]

Is it actually just randomly moving up and stopping filament feed or just failing to extrude properly (jamming)?

It randomly moves up. I’ve actually watched it happen one time

 

[zakstang]

Did it operate properly before the bltouch???? i have not added any mods to my ender 3 v2 and once i got bed level (kind of a pain but once set its been fine) it has been flaw less...maybe remove bltouch and see if thats the issue????

 

[teh603]

Agreed, did you try it before the BLTouch? Sounds like either a bad firmware flash or bad gcode.

Sponsored