Search results

What drew me into it was a customer at the time who required all field service agents have a UHF/VHF radio to communicate when working in the California and Arizona deserts as some of their facilities did not allow cell phones (i.e. secured locations - no devices with cameras, memory storage)...

I use my Midland 75-822. Its a handheld that fits in that same mount. It offers the ability to also use an external antenna if I want as it comes with a cable/adapter. I am still trying to figure out how to make the mount work while using that configuration. I personally don't run an external...

Attached is the current iteration of the mount. Its the same mount for all 3 radios. All you need is a cubby mount with the FITS connector. I am still tweaking it a bit to better accommodate one radio with a longer antenna. Once I get it worked out, I will upload that version.

Yes. At this point, both my FE and Tremor have identical values and everything works in both.

I am not near you,. but I added it to mine. It was pretty easy. You have to change 2 values: SDM - ABS change from enabled to disabled SDM - Sport change from disabled to enabled When I first added it, I missed changing the ABS one so the modes were there but I got messages they were not...

The Alter Ego Twins side by side in the driveway: 22 Rapid Red Hybrid & 23 Atlas Blue Tremor Always fun to see them paired up. And this reminds me, I gotta mow/trim/edge the yard today LOL

Updated with recall notice: I went to go get the Sync software update for a manual install. It was clear then. After the install when I went back to the site to upload the XML file, I had a recall appear.... Its almost a week old since it's issue date even though it only showed up today...

I got to thinking and I wanted to add this to further add weight to the possibility it might be diseling: Listen to the original poster's 4th video at the end and note the sound. Then listen to this video of an old Dodge D1 dieseling: Gas engine dieseling doge d100 - YouTube The first 30...

My take is that we need more people to test things to rule out as many possibilities as we can, and changing gas stations is probably the least intrusive. What we know: The engine is continuing to cycle for a second or two or even longer after the ignition is cut. Others in the thread have...

Maybe not the best way to say it, but when it goes from gas side shutting down to only electric.

Its a 'service life' thing where any new vehicle has to have the same parts available for a number of years after the vehicle is produced. And yes, I was able to change drive modes. I forgot to disable the first setting under ABS Module, but once I set that, it works.

ForScan Steps: Before you begin, if you have never set up ForScan with the OBDLink-EX cable, connect the cable to a USB port and see if the light turns yellow. If the light is red, the drivers are not yet installed. If they do not install automatically after a few minutes, then you can download...

Thats why I wanted to watch this thread in case it comes back for me. Mine would do it for 2 to 3 seconds and it sounds scary when it happens.

I got my JOB1 controls from Tasca Parts. Order Ford Part Number: NZ6Z-19980-B (Link goes to Tasca's page to order it). Its not too complicated, but I know I'd miss steps right now trying it from memory. I will go in and get some screenshots and put a walkthough post in this thread a bit later...

The sound in the last video at the very end (48 seconds).... Mine has made that same noise before, but it has been a good long while since I last heard it. Only happens when switching from ICE to electric, and usually while slow or stopped. It reminded me of an old Plymouth my parents hat that...

The US FM Band plan only runs from 88MHz to 108MHz. FM broadcast band - Wikipedia Some older vehicles, portables, etc, can tune lower than that for a mix of reasons with the biggest one being that its cheaper to make one radio receiver for multiple regions that can go lower. With that said...

First, a big thank you to @Redneck Garage for his video on changing out the climate controls. I just did this on my Tremor today. As they do require some tweaking via ForSCAN, I wanted to see if I could get some help on something. The AsBuilt on the Tremor before making changes with the...

My bad. :) I did check and I did find a post referencing Tim saying you can, but has to be done before it actually goes into production: 📬 5/18/23 Scheduling Email Received Group [EMAILS NOW ARRIVING] | Page 18 | MaverickTruckClub - 2022+ Ford Maverick Pickup Forum, News, Owners, Discussions...

Many automakers share things. Like the old Fusion being a "sister' to the Kia Optima/Hyundai Sonata, but not so close they are too alike, or the old Rangers and Mazda B-series pickups, the Escape and Kia Seltos, or better yet, the 10R Transmission in my Bronco, a.k.a. the Ford-GM Transmission...

Unfortunately, once the VIN is issued, you can't make changes.