Search results

I agree they should be AGM, but the Hybrid needs RC, not CCA. The High voltage battery starts the hybrid ICE.

Check your colors for 2025, some were added, some were removed from the previous years. I see Azure Grey and Velocity Blue. The Azure grey has a blueish tint, that's probably what you meant.

Before upgrading the B&O audio, upgrade your source. The XM stream from your phone might be better quality, but XM over the air is not. I ripped my CDs to FLAC, there are some threads about a portable CD player that plugs in and works.

Welcome to the club!

You were hit harder than I was. Hopefully there were no injuries. Now, according to your username......

keep in mind the matte black would be opaque, not see through. This would increase the blind spot from at your a-pillar by increasing the width of the non-visible area.

I'm not surprised there was no frame damage, the impact was all transferred to the occupants back then. That was before the mandated crumple zones.

Wasn't my experience at 3 months and 3,000 miles old. Estimating it cost me at least $6000 to "rent" it.

Start removing anything you added and want to keep. If it isn't deemed totaled, they didn't look at it very well. I had no visible damage until the plastic was removed on the passenger side and then I still can barely feel or see the stress mark on the "frame". Measurements have the...

yep, my mistake, but now both the EB and the Hybrid are covered :)

FYI, your link goes to size: BCI48/H6/L3/66L3 Many threads here state the proper size that does not require cutting the tabs on the floor at either end to accommodate the length of the battery is BCI140R/H4/LN1 @ $150.99 and 25% off coupon...

:) only the 12 volt battery, not the High voltage one.

They have an Amazon page so there is a distribution channel already, but this isn't listed...yet:). I didn't find a way to contact seller yet though so maybe someone smarter at Amazon can facilitate: https://www.amazon.com/stores/NKOK/Homepage/page/6829B334-7735-413C-B4B0-FB0D192A964B

From my time selling auto parts, the alternator reps would not approve of the steps above. In the 80's when vehicles started getting 70+ amp alternators they recommended turning off the booster vehicle before starting the disabled one so the alternators weren't both charging at the same time. It...

I believe the black cap you have uncovered says not a jump point. That is not a negative post. https://www.mavericktruckclub.com/forum/posts/718615

There is a bar across the back whether or not the receiver is purchased (part 5 or 6): https://parts.lakelandford.com/a/Ford_2022_Maverick/105746403__10804937/Rear-bumper-Bumper--components/MM22805.html#6 I was rear-ended with about 25mph difference in speed. I was not yet stopped and had just...

The 4th picture looks like it shows they are not solid.

My air bags, no. The van that hit me, yes! unobserved damage shown on 3rd page https://www.mavericktruckclub.com/forum/posts/967357

See my avatar for my trucks name....well what I've been calling it until I was rear-ended, now I might call it Humpty....as in Humpty Dumpty https://www.mavericktruckclub.com/forum/threads/it-happened-anyway-rear-ended.56511/

It isn't the bumper and tailgate, it's the stress mark in the "frame". Boron steel is un-repairable, all of the back of the truck is spot welded to it including 1/2 the cab. It is very hard on the bits to drill out the spot welds, and has to be re-spot-welded correctly or the steel around the...