Can I connect my G40 directly to the 12v battery and then plug the USB charging cable into the rear seat usb port? Will running the truck keep the G40 topped up and ready to boost the 12v battery when necessary or will it drain the 12v?
Dealer quoted 9 hrs to replace $400 cabin heater core……seem about right? Reason is too hard/sad/funny to believe…..left a candle on the dash close to defrost vents, melted and ran down into dash heater…..now HVAC controls dont do much…..
I own an ordered 2022 Hybrid XLT, live in cold Canada….since ownership I have been concerned by the indicated temp on the gauge. In mind, the gauge should always read mid temp, winter summer highway town…an ICE makes and needs heat to run at its peak. Has anyone put a winter front on the grill...
Has anyone tried the smallest non Maverick specific box tents made by Napier? I understand there may be some comprises needed. Reason I ask is the Napier Maverick model is big bucks and very hard to find. I feel Napier has a good reputation when it comes to box tents
thx
would the Napier bed tent still work if you had a plywood sub floor sitting on top of the wheel wheels? Other than extra material in the bed would there be any pitfalls to doing this? I would open up a lot of extra storage this way but at what expense?
I remember reading something about possible electric fires on hybrids and not to park them in a garage, has there been any updates to this? Can some one direct me to the actual Ford publication?
thanks in advance
Can I do this? My chances of this happening are soooo slim and even if this modification is made, there is no guarantees that you will not still have a engine fire (which in the case of a new car you hope that whole damn thing goes up in smoke ) I can live with a hole in the aero panel under...
My DIBL installed at factory on XLT Lux Hybrid does not have cut outo on the side panels For 12v ports. I looked at a used XLT on the lot and its DIBL has beveled openings for the 12v acc plug on both side. I am going to have dealer remove side panels and check if the cutouts are there, but...