Search results

I ordered a bare harness from LLJ customs a month ago and have not received it yet. Tried emailing them and texting and no replies in two days. That's not good service. 😐

I used #6 for my sub amp turn on and works great.

I don't know who made it but seems like a very high quality product and has the ford logo embossed in the top. The box just had ford stock numbers on it that did not indicate the maker. There were no aftermarket ones available at that time and I used $200 worth of Ford pass points to pay for it...

I have a 4 channel kenwood amp that I will mount to this, thanks for your hard work.

I tapped into fuse #6 for a remote turn on for my sub amp and it works perfectly.

Took the signal from the front and fed it directly to the high level inputs of my amp. The amp has a low pass crossover switch that activates at 120hz.

Moved the fuse closer to the battery as suggested by a few posters.

16 inch long, 9 inch wide on the top, 7 inch wide on the bottom and 9 inches deep.

I've heard that comment a few times so maybe I will move it next to the battery. Thanks.

I'm very impressed with the 8 inch Blaupunkt sub. I had twin 10 inch rockfords in my f150 and this seems to hit as hard and sounds as clean at 1/4 the price.

Complete install of 8 inch subwoofer in custom made box. Box was made from 3/4 inch mdf that was shaped to optimize the space in one of the under seat storage sections. It was easy to run the power from the battery through the firewall and hide it under the trim. The signal was tapped from the...

I tried to order the bare harness listed at $40 but when I go to pay the price changes to $75. I tried to message the site but no response in 5 days.

Use a screwdriver to pop the damper off. It goes back on easy.

The rear speaker do not have a common ground. They are wired the same as the bronco sport in the attached picture.

Added sport and Ecco mode using the easy method. All modes work but noticed sport mode shuts off auto start. I'm not sure if it normally does this in sport mode. Anybody know if this is normal?

Just had my gas tank inspected at dealer and it passed, yay. Dropped it off at 930 and will be ready to go at 4. I'm happy to get Marvin back so I can install my new speakers.

Would you have a wiring diagram that shows where I can find a source of rap for an add on amplifier?

I was going to chop up the old tweeter and solder the wires to the connector on it. Then I wouldn't have to cut off the connector for the factory wiring.

Looks good, I'm trying to decide whether to go with subs or new component speakers first.

Do you have any pix of the sub?